Nikon 6MA03711-A Manuel D’Utilisation
More on Photography
42
Using the ML-L3 Remote Control
To use the ML-L3 remote control:
To use the ML-L3 remote control:
1
Mount the camera on a tripod (recommended) or place it on a stable, level
surface.
2
Press the
( ) button to select self-timer mode (
41).
3
After framing the photograph, aim the remote con-
trol transmitter at the camera infrared receiver and
press the shutter release on the remote control.
press the shutter release on the remote control.
Using the Remote Control
The ML-L3 has a range of about 5 m (16´). Be sure
the line of sight between the remote and the infra-
red receiver is not blocked by converter lenses, lens
hoods, or other obstacles. Note that the remote
may not function if the receiver is too brightly lit.
the line of sight between the remote and the infra-
red receiver is not blocked by converter lenses, lens
hoods, or other obstacles. Note that the remote
may not function if the receiver is too brightly lit.
4
The camera will take a picture about two seconds
later. The self-timer lamp will blink for the fi rst sec-
ond and then remain lit until the shutter is released.
Self-timer mode remains in effect after the shutter
is released, allowing additional pictures to be taken
using the remote.
ond and then remain lit until the shutter is released.
Self-timer mode remains in effect after the shutter
is released, allowing additional pictures to be taken
using the remote.
The Self-Timer
When the self-timer is turned on, BSS turns off automatically (
91). If an option
other than Intvl timer shooting is selected for Continuous (
88), Continuous will
automatically be reset to Single.
The self-timer is not available in movie mode (
58),
or when (Museum), (Fireworks show), or (Sports) is selected in scene mode
(
(
26).
Infrared receiver
Self-timer
lamp