Fujifilm FinePix S1 Manuel D’Utilisation
Flash Photography - continued
76
Exposure Mode
AUTO mode
Programmed auto
5-vari program
Shutter-priority auto
Aperture-priority auto
Manual
Valid Shutter Speeds
Automatically set by
the camera
1/125 to 30 sec. *1
Automatically set by
the camera
1/125 to 30 sec. *1
Ref. Page
☞
P.60
☞
P.61
☞
P.66
☞
P.62
☞
P.63
☞
P.64
Valid Apertures
Automatically set by
the camera
Any aperture *2
*1: If a shutter speed faster than 1/125 sec. is selected, the shutter speed is
automatically reset to 1/125 sec. when the flash unit pops up. (When a Nikon
flash unit is used, the shutter speed is reset when you switch the flash unit on.)
flash unit is used, the shutter speed is reset when you switch the flash unit on.)
*2: The flash control range is determined by the ISO sensitivity and aperture settings.
When you set the aperture in aperture-priority auto or manual mode, allow of the
flash control range shown on P.74.
flash control range shown on P.74.
1
Press the flash lock release button so that the flash
pops up. Then hold down the synchro mode button “
pops up. Then hold down the synchro mode button “
j
”
and turn the command dial to set the synchro mode.
• When the flash pops up, it starts charging. When charging is complete,
the Ready icon “
j
” appears in the viewfinder display.
• When normal synchro mode “
j
” is selected, the “
j
” on the top display
panel disappears when you take your finger off the synchro mode button
“
“
j
”.
• To stow the flash, push it down gently by hand.
• The built-in flash cannot be used when the battery adapter is used.
• The built-in flash cannot be used when the battery adapter is used.
2
Set the exposure mode and check the shutter speed
and aperture setting.
and aperture setting.
• The table below shows the shutter speeds and aperture settings that can
be specified in each of the exposure modes.
Taking Pictures Using the Built-in Flash