VIVOTEK IP3135 Manuel D’Utilisation

 

 

 
 

 
 
 

 

  

www.vivotek.com 

 

 

 

 
 

After powering up, the Network Camera performs a self-diagnostic to detect any 
hardware defects. The following table lists the LED patterns in general. In case of any 
fatal error, the LED will blink in a pattern other than those below. 

Condition LED 

color 

During self-diagnostic after power on 

Blink in interchanged green and red 

Ethernet signal is lost 

Steady red till Ethernet is detected 

Before network is setup 

Steady green till IP address is confirmed 

After network is setup 

Blink green every second 

Network is setup and audio is disabled 

Blink green every 4 seconds 

Any hardware failure 

Other patterns 

 

 
 
 

There is a button in the back of the Network Camera. It is used to 
reset the system or restore the factory default settings. 
Sometimes resetting the system sets the system back to normal 
state. If the system problems remain after reset, restore the 
factory settings and install again. 
RESET:    

Click on the button. 

RESTORE:    1. Press on the button continuously. 
2. Wait for self-diagnostic to run twice. 
3. Free the button as soon as the second self-diagnostic starts.

  Restoring the factory defaults will erase any previous settings. Reset or restore the 

system after power on.