Philips Video Camera Manuel D’Utilisation

16

17

AUTO SCAN SETUP

SCAN 01                         : AUTOSCAN01
SPEED(MODE)                 : FAST VECTOR
START ANGLE                 : 127.1, 027.7  X7
END ANGLE                     : 157.7, 080.7  X13
SCAN DIR.                       : CCW
SWAP                             : OFF
SAVE AND EXIT (ESC TO CANCEL)

HOLD DOWN CTRL KEY
WHILE SELECT POSITION.

(First Item of the Main menu / Shortcut: 

Scan)

The Auto scan supports up to 8 programmed angles at user-programmable speeds. Follow these steps to program Auto Scan:

1.  Press the 

Scan key to enter Auto Scan menu directly. Or press the Menu key to display the main menu on the monitor. Scroll to Auto Scan and push the 

    

Joystick to the right.

2.  Select an Auto Scan number by pushing the 

Joystick left or right.

3.  Twist the 

Joystick to enter the title by scrolling through the alphanumeric characters and pushing the handle to the right or left to move to the next space. 

      Press 

Enter key or push the Joystick down to finish title mode. Press HOME key in order to delete stored alphanumeric characters.

4.   Push the 

Joystick downward to select „Speed” and set the speed by twisting the Ctrl/PGM keyclockwise or counterclockwise or moving the Joystick left 

and right to select the auto scan speed.

5.  When finish entering the title and speed, select „START ANGLE” with the 

Joystick. Hold down the Ctrl/PGM key while selecting the start position and zoom  

     using the 

Joystick. Current panning position will be displayed. Release Ctrl/PGM key to complete the selection of the start position.

6.   Push the 

Joystick downward to select „END ANGLE.” Hold down the Ctrl/PGM key while moving the Joystick to select the end position and zoom. The 

end position angles should be larger than start position. Release the 

Ctrl/PGM key to complete the selection of the end position.

7.  Select Save and Exit by pushing the 

Joystick to the right. Press ESC to exit the program without saving.

a.  Before entering the Auto Scan menu, select a preset position as a starting point for Auto Scan.
     Example: 2  + Prst and do step 1 to 4. Instead of step 5, just press the Ctrl/PGM key at the start angle position, the current position will be displayed as a  
     start position.
b.  Save and exit from the menu.
c.  In normal mode, call a preset to be the end point of scan. Press 

3 + Prst then press Scan key to enter the Auto Scan menu. Move the cursor position to 

     END ANGLE. Just press 

Ctrl/PGM key at the end angle position. Do step 7.

Example: Preset 001>002>003>004>005>006, Auto Scan 01 starts at 002, ends at 003,  Auto Scan 02 starts at 005, ends at 006.  Tour 001, 002, A01, 004, 
A02. 
1    2   2~3   4    5~6   1   2 2~3 ......
Where       : Quick move,   ~ : Programmed speed by Auto Scan.

SPEED (MODE):      NORMAL1~NOMAL9, SLOW VECTOR, FAST VECTOR
                               NORMAL1 (SLOWER) <––> NORMAL9 ( FASTER)
                               SLOW VECTOR, FAST VECTOR: Move from start point to end point including tilt and zoom simultaneously and linearly. 
                               In case of EDC-143E, EDC-142E1 and EDC-142E2, zoom is fixed at more wide angle and the zoom magnification information is not 
                               displayed.