Philips LTC0600 Manuel D’Utilisation

13

12

8

9.1  HOW TO SET UP YOUR CAMERA
The camera has 8 buttons which can be operated from the side of the camera. Feedback is
provided by means of On Screen Display. Extended setup functions are possible via the
software configuration tool.

Mode

=  Mode selection

LVL

=  Video Level

BLC

=  Back Light Compensation

AWB

=  Auto White Balance 

LL

=  Linelock

Phase

=  Linelock-phase, H-phase or Vext phase 

+

=  Increase  or  On

-

=  Decrease or Off

After pressing a function button, the – or + buttons operate on the selected function:

–  : Decrease or Off
+  : Increase or On

These functions automatically increase when the button is depressed for a longer period.
For all functions the - and + actions are positive choices.There are no toggle functions and
no cycles.

Digital Colour Camera

 BNC composite video

 Y/C 4 pin connector or

 Balanced 4 pin connector

(selectable via PC software)

7.4  SYNCHRONIZATION
CONNECTION (SYNC)
The vertical and horizontal camera
synchronization signals can be generated:

•

internal x-tal;

•

by the mains supply or the AC low
voltage supply (50/60 Hz);

•

by a video signal from an external
source (PAL/NTSC), sync input
BNC

;

•

by a synchronization signal from an external source, sync input BNC 

.

The camera automatically configures for the applied external synchronisation.
For adjustment see chapter 9.

7.5  REMOTE CONTROL CONNECTION (RS-232)
The camera can be set up using an optional Windows based PC software tool.
This product can be ordered separately.

Functions available with this software tool are: AGC manual, Automatic. Electronic Light
Control (ELC). Dynamic Contrast. Gamma/Compression/Contour, OSD remainder text,
Camera set-up logbook etc.

RS-232 communication: Pin 3 = Rx, Pin 2 = Tx, Pin 5 = GND
pin 4,6,8,9 are not connected

.

Hard wire mode switch between current mode and mode 3
Connect Pin 1 to pin 5 (GND) by a switch. (refer to chapter 9.2.1)
Input pin 1: 10kΩ to +5V. Default active Low. Selection Active High or Disable via PC
configuration tool.

•

Camera system remote control.

•

Mode selection

•

Advanced Camera set-up via PC based Configuration tool LTC 0650/00.

The windows based configuration is a separate Philips product which is not included with
the camera itself. Functions available with this software tool are: Mode set-up and PC
logging. AGC manual, Boost, Automatic. Electronic Light control (ELC). Dynamic Contrast.
Gamma/Compression/Contour/Black level. Input/output functions and impedance
selections.

9

1

1

2

3

4

5

6

7

8

9

2

3

+

4

–

                                       

H-V LOCK

Y/C OUT/ Balanced

CVBS OUT

Sync. Input

Video output

Video output

Ground

N. C.

Rx

Tx

Mode 

switch

N. C.

N. C.

N. C.

N. C.

RS232 4