Nikon S9400 Manuel D’Utilisation

Step 1 Turn the Camera On

The 

Basic

s of 
Shootin

g

 and Playback

• When the camera is turned on, the power-on lamp (green) lights and the 

monitor is turned on (the power-on lamp turns off when the monitor is turned 
on).

• To turn off the camera, press the power switch. Both the monitor and the 

power-on lamp are turned off.

• To turn on the camera in playback mode, press and hold the 

c (playback) 

button. At this time, the lens does not extend.

• When Record GPS data in GPS options of the GPS options menu is set to On, 

GPS functions will continue to operate even after the camera is turned off 
(

C

If no operations are performed for a while, the monitor will turn off, the camera will enter standby 
mode, and the power-on lamp will flash. If no operations are performed for another 3 minutes, the 
camera will turn off automatically.

• To turn on the monitor again in standby mode, perform either one of the following operations.

- Press the power switch, shutter-release button, 

c button, or b (e movie-record) button.

- Rotate the mode dial.

• The time that elapses before the camera enters standby mode can be changed using the Auto off 

setting in the setup menu (

A96).

• By default, the camera enters standby mode in about 1 minute when you are using shooting 

mode or playback mode.

• If you are using the AC Adapter EH-62F (available separately), the camera enters standby mode 

after 30 minutes. This setting cannot be changed.

C

Battery power drains faster than usual while the camera is recording log data (

A92) or using a Wi-Fi 

connection (