Nikon D5200 (18-105mm Kit) Mode D'Emploi

176

This option is displayed only when an Eye-Fi memory card (available separately from 
third-party suppliers) is inserted in the camera. Choose Enable to upload 
photographs to a preselected destination. Note that pictures will not be uploaded if 
signal strength is insufficient.

Observe all local laws concerning wireless devices and choose Disable where 
wireless devices are prohibited.

When an Eye-Fi card is inserted, its status is indicated by an icon 
in the information display:
•

d: Eye-Fi upload disabled.

e: Eye-Fi upload enabled but no pictures available for 
upload.

f (static): Eye-Fi upload enabled; waiting to begin upload.

f (animated): Eye-Fi upload enabled; uploading data.

g: Error.

A

h Icon

Connection status is shown by the 

h icon:

h (static): Camera has established communication with GPS unit. 
Photo information for pictures taken while this icon is displayed 
include an additional page of GPS data (

h (flashing): The GPS unit is searching for a signal. Pictures taken 
while the icon is flashing do not include GPS data.

• No icon: No new GPS data have been received from the GPS unit for 

at least two seconds. Pictures taken when the 

h icon is not 

displayed do not include GPS data.

G button

➜ B setup menu

D

Eye-Fi cards may emit wireless signals when Disable is selected. If a warning is displayed in 
the monitor (

0 228), turn the camera off and remove the card.

See the manual provided with the Eye-Fi card, and direct any inquiries to the manufacturer. 
The camera can be used to turn Eye-Fi cards on and off, but may not support other Eye-Fi 
functions.

A

As of October 2012, the camera supports 8 GB SDHC Pro X2 Eye-Fi cards. Some cards may 
not be available in some countries or regions; consult the manufacturer for more 
information. Eye-Fi cards are for use only in the country of purchase. Be sure the Eye-Fi card 
firmware has been updated to the latest version.

A

Additional time may be required when connecting using Eye-Fi cards that support ad hoc 
mode. Select longer values for Auto off timers > Standby timer in the setup menu (