Siemens 6AU1900-1AB32-0BA0 Manuel D’Utilisation

 

Functions 

 

4.9 Specify parameters for target device 

CamTool 
Configuration Manual, 12.2004, 6AU1900-1AB32-0BA0 

4-33

 

Scaling 

You can specify the scaling for the target device here. 

 

 

Notice 
To display the scaled curve, select menu Cam > Representation parameters > Display 

scaling. 
If the scaled curve is displayed, you cannot edit the original curve. To edit the original curve 

again, reselect menu Cam > Representation parameters > Display scaling. 

 

You can set the following parameters: 

Table 4-6 

Parameters in the Scaling tab (Target Device Parameters window) 

Field/button 

Explanation/instructions 

Master axis 

 

 

Basic scaling 

Enter the basic scaling of the master axis here. The center of the scaling 

is always the coordinate origin.  
Note:  
Do not use any scaling values which are greater than 5. Greater values 

cause a roughness in the curve characteristic. 

 

Scalings 

You can specify the scalings of two ranges of the master axis here. The 

center of the scaling is the start point of the scaling range.  
Note:  
If you specify two ranges, the ranges cannot overlap. 

 

 

(Range1) 

Under From and To, enter the range that you want to scale. Under 

Factor, enter the scaling factor.  
Note:  
Do not use any scaling values which are greater than 5. Greater values 

cause a roughness in the curve characteristic. 

 

 

(Range2) 

Under From and To, enter the range that you want to scale. Under 

Factor, enter the scaling factor.  
Note:  
Do not use any scaling values which are greater than 5. Greater values 

cause a roughness in the curve characteristic. 

 

Offset 

You can enter a factor for the offset of the master axis here. If you have 

specified a scaling, the offset applies to the scaled curve. If you have not 

specified a scaling, the offset applies to the unscaled curve.