SonicWALL SRA 1200/4200 Manuel D’Utilisation

SonicWALL SRA 1200/4200 Getting Started Guide  

Page 9

Applying Power to the SonicWALL SRA

1.

Plug one end of the power cord into the 
SonicWALL SRA 1200/4200 and the other into an 
appropriate power outlet. 

2.

Turn on the power switch located on the rear of the 
appliance next to the power cord.

The 'Pwr' LED on the front panel lights up blue when the 
appliance is turned on. The 'Test' LED lights up yellow and may 
blink for up to a minute while the appliance performs a series of 
diagnostic tests. When the 'Test' LED is no longer lit, the 
SonicWALL SRA 1200/4200 is ready for configuration. 

If the 'Test' or 'Alarm' LEDs remain lit, or if the 'Test' LED blinks 
red after the SonicWALL SRA 1200/4200 has booted, restart 
the appliance. For more troubleshooting information, refer to the 
SonicWALL SSL VPN Administrator’s Guide.

Accessing the Management Interface

To access the Web-based management interface of the 
SonicWALL SRA 1200/4200: 

1.

Connect one end of an Ethernet cable into the ‘X0’ port of 
your SonicWALL SRA 1200/4200. Connect the other end 
of the cable into the computer you are using to manage the 
SonicWALL SRA 1200/4200. 

2.

Set the computer you use to manage the 
SonicWALL SRA 1200/4200 to have a static IP address in 
the 192.168.200.x/24 subnet, such as 192.168.200.20. 
However, do not use 192.168.200.1, as this address will 
conflict with the appliance.

3.

Open a Web browser, and enter http://192.168.200.1 (the 
default X0 management IP address) in the Location or 
Address field. 

PWR

TEST

ALARM