Sony Ericsson PDW-530 Manuel D’Utilisation

Page de 168
Chap
ter
 8
   Set
ting Up th
e C
a
mc
orde
r
114
8-1 Power Supply
Detaching the battery pack
Detaching the battery pack
Note 
During recording or playback (while the ACCESS 
indicator is lit), be careful never to remove the battery 
pack.
8-1-2 Avoiding Breaks in Operation 
Due to an exhausted Battery
When the battery pack is becoming exhausted, you can 
perform battery replacement without causing a break to the 
camcorder operation by using an AC adaptor.
To do this, proceed as follows.
1
Connect an AC-550/AC-550CE Adaptor to an AC 
power source, then connect it to the DC IN connector 
of the camcorder.
For details, see the next section.
The power source switches automatically from the 
battery pack to the AC adaptor connected to the DC IN 
connector.
Note
There may be some noise on the video signal at the 
time of power source switching.
2
Replace the battery pack with a fully charged one.
3
To switch back the power source from the AC adaptor 
to the battery, disconnect the AC adaptor from the DC 
IN connector.
8-1-3 Using an AC Adaptor
Using the AC-550/550CE AC adaptor
Connect the camcorder to the AC power supply through 
the AC-550/550CE AC Adaptor as shown in the following 
figure, and turn the POWER switch of the AC-550/550CE 
on.
Using an AC Adaptor
Using the AC-DN2B AC adaptor
Mount the AC-DN2B on the camcorder in the same way as 
a battery pack, then connect to the AC power supply. The 
AC-DN2B can supply up to 150 W of power.
Connecting to an AC power source using the AC-DN2B AC Adaptor
8-1-4 Using the Anton Bauer 
Ultralight System
By fitting the camcorder with the Anton Bauer Ultralight 
system, and setting the LIGHT switch to AUTO, you can 
switch the light on and off automatically as you start and 
stop REC operation. This system operates with lights 
powered by 12 V, with a maximum power consumption of  
50 W.
Holding the 
button in, pull 
the battery 
pack up.
ACCESS 
indicator
to an AC power source
Power switch on
AC-550/
550CE 
AC Adaptor
DC OUT
DC IN
DC output cable (supplied with 
the AC-550/550CE)
to an AC power 
source