Sony EVI-H100S Manuel D’Utilisation

Locations of Controls

 RS-232C/RS-422 select switch

Set to ON to operate colour video camera using the

VISCA command via the RS-422 interface. To change

the mode, turn off the camera (not including standby

mode) first, set the switch and then turn on the camera

again. The mode cannot be switched while the camera is

turned on.

 Baud rate select switch

Set to ON for 38,400 bps or OFF for 9,600 bps. To

change the mode, turn off the camera (not including

standby mode) first, set the switch and then turn on the

camera again. Mode switching is not possible while the

camera is turned on.

 Switch 5 (Not used)

Be sure to set this switch to OFF.

 Tripod screw hole
 Ceiling bracket mounting screw holes

Remote Commander

 CAMERA SELECT buttons

Press the button corresponding to the camera you want to

operate with the Remote Commander.

The camera number can be set using the IR SELECT switch

on the rear of the camera.

Note

If two or more cameras are adjacent and have the same

camera number, they are operated simultaneously with the

same Remote Commander. When you install the cameras

close to each other, set different camera numbers.

For the camera number setting, see “Operating Multiple

Cameras with the Remote Commander” described in the

Operating Instructions supplied with the camera.

Pin No.

Function

Data_2-

Data_2+

Shield (2, 4)

No connection

Analog Vertical Sync

Data_1-

Data_1+

Shield (1, 3)

No connection

Power_+ V

GND

Hot Plug

Data_0-

Data_0+

Shield (0, )

No connection

Shield Clock

Clock+

Clock-

Analog Pr

Analog Y

Analog Pb

Analog Horizontal Sync

Analog GND

 VISCA IN connector
 VISCA OUT connector
 DC 12V connector
 BOTTOM switches

 D70 mode switch

Set to ON to use the VISCA command for EVI-D70/

D70P.

 IR OUT switch

Set to ON to enable output of the receiver signals, which

are transmitted from the infrared remote commander

via the VISCA IN connector (page 27), or set it to OFF

to disable the output.