Hitachi DZ-HS903A Manuel D’Utilisation
51
Vi
ew
in
g
z Specifying the point to jump
to
1
Select “Specify” in step
in
“Jumping to the designated scene”
(p.50), then press the confirmation
button.
(p.50), then press the confirmation
button.
The specify screen will appear.
2
Select the desired point by time by
pressing f / e / d / c.
pressing f / e / d / c.
f
:
To select the beginning
e
:
To select the end
d
/ c once:
To move the cursor one
minute back or forward
for HDD (ten seconds for
DVD, one still for card)
minute back or forward
for HDD (ten seconds for
DVD, one still for card)
Press and hold d / c:
To move the cursor in ten
minutes increments for
HDD (one minute for
DVD, ten stills for card)
minutes increments for
HDD (one minute for
DVD, ten stills for card)
GO TO
0 : 0 0 : 0 0
0 : 00: 45
0 : 00 : 10
0 : 00 : 10
TOP
END
CURRENT
TOP
END
ENTER
CANCEL
Go t o
Position of currently
played back image
Total recording time
of all selected scenes
Cursor
Cursor position
GO TO
0 : 0 0 : 0 0
0 : 00: 45
0 : 00 : 10
0 : 00 : 00
TOP
END
CURRENT
TOP
END
ENTER
CANCEL
Go t o
(When the start of the
selected scene is selected)
3
Press the confirmation button.
The camcorder will go to the
specified point and enter playback
pause mode.
• To start playback, press the
specified point and enter playback
pause mode.
• To start playback, press the
confirmation button again.
Hints
• To cancel the “Go To” procedure
midway, press C before going to
the specified point.
the specified point.
• With a card, the number of stills
will appear at the “Top”, “Current”,
“End”, and “Go To” indicators.
“End”, and “Go To” indicators.
Note
The cursor position is a rough
estimate. The cursor may not move
at even intervals.
estimate. The cursor may not move
at even intervals.
DZ-HS903-803-US-Ea_IM_v01d05n02.p.book Page 51 Friday, September 12, 2008 8:22 PM