Hitachi DZ-GX5100SW Manuel D’Utilisation

Page de 153
En
g
lish
139
During recording
Symptom
Cause and Correction
Reference 
page
Pressing the REC 
button will not start 
recording.
• Is input image copy-guarded?
• Is a finalised disc in the DVD video camera/recorder?
• Is proper type of disc inserted?
• Is power switch set to match the recording medium?
• Is the disc protected?
• Does disc have remaining recording space?
23, 30, 99, 
101
Recording starts but 
stops immediately.
Is disc scratched or does dirt or fingerprint adhere to it?
Clean the disc. If there is still no improvement, replace the disc.
9
Is some other AV device directly connected to the video/audio 
input/output jack of this DVD video camera/recorder?
If the AV device is connected via several other devices, such as 
AV selector, the video signal may not be transmitted incorrectly. 
In such a case, reduce the number of devices through which the 
video signal is transmitted, or connect AV device directly.
108
Are you attempting to record image from video game or PC?
From some video games or PCs, image cannot be recorded on 
this DVD video camera/recorder.
No photo can be 
recorded.
• Is proper type of disc or card inserted?
• Is power switch set to match the recording medium?
• Is the disc protected or the card locked?
• Does disc or card have remaining recording space?
23, 26, 32, 99
LCD screen is hard to 
see.
Has brightness of LCD screen been adjusted?
Stop recording and adjust the brightness.
35
Is the DVD video camera/recorder being used outdoors?
Use the viewfinder. When using LCD monitor, adjust its angle so 
that LCD screen is not exposed to direct sunlight.
31
Unevenness appears on 
LCD monitor screen.
Did you press the LCD monitor or the area around it?
If the LCD monitor is pressed, some unevenness will occur. 
Release your hand and leave the LCD monitor for a while: 
Normal display will be restored.
Focus is not correct.
Is it difficult to use auto focus with your subject?
Focus manually.
53
Does manual focus icon appear?
The DVD video camera/recorder is set to manual focus. Focus 
the subject manually, or release manual focus.
52
Is the dioptre control correctly adjusted if you are using the 
viewfinder as a monitor?
Adjust the dioptre control.
31
In cases other than the above, set the power switch to “OFF”, and 
then set it to “
!
”, “
 
” or “
"
” again.
30
An error message for 
repair appears.
Perform repair following the instructions on screen. 
Repair is possible when the DVD video camera/recorder is powered 
by the AC adapter/charger.
It will take from a few minutes to several hours for repair. If you 
wish to start recording immediately, remove the disc, and then 
insert another disc: The removed disc can later be repaired by 
connecting the AC adapter/charger.
25