Radio Shack TAD-704 Manuel D’Utilisation
10
TAD OPERATION
RECORDING THE
OUTGOING MESSAGES
OUTGOING MESSAGES
Before the TAD-704 can answer calls
and record messages, you must record
an outgoing message (OGM). The TAD-
704 lets you record two separate mes-
sages, and it operates differently based
on which message you select.
and record messages, you must record
an outgoing message (OGM). The TAD-
704 lets you record two separate mes-
sages, and it operates differently based
on which message you select.
OGM 1 — After playing your outgoing
message, the TAD records the caller's
message.
message, the TAD records the caller's
message.
OGM 2 (announce-only) — The TAD
plays your outgoing message, but does
not record a message.
plays your outgoing message, but does
not record a message.
Notes:
• The maximum length for each out-
going message is 32 seconds. As
you record, the message counter
shows the recording time.
you record, the message counter
shows the recording time.
• If you plan to use the TAD's
announce-only feature, OGM 2
should clearly state that the caller
cannot leave a message.
should clearly state that the caller
cannot leave a message.
•
OGM1
or
OGM2
on the display stops
flashing to indicate OGM1 or OGM2
is recorded.
is recorded.
Follow these steps to record an outgoing
message.
message.
1. To record the OGM 1 (or OGM 2)
message, hold down
OGM1
(or
OGM2
) until the TAD beeps and the
timer starts counting.
OGM1
RECORDING
(or
OGM2
RECORD-
ING
) appears.
Note: As soon as the TAD beeps,
release
release
OGM1
(or
OGM2
) quickly.
Otherwise, the TAD records a “pop”
sound at the beginning of the outgo-
ing message.
sound at the beginning of the outgo-
ing message.
2. Speak your message from about 8
inches in front of the TAD.
3. When you finish, press
STOP
. The
TAD beeps and plays back the out-
going message.
going message.
CHECKING THE
OUTGOING MESSAGES
OUTGOING MESSAGES
To check an outgoing message, press
its button (OGM1 or OGM2).
its button (OGM1 or OGM2).
OGM1
PLAYING
(or
OGM2
PLAYING
) ap-
pears and the message plays.
If no outgoing message is recorded
when you press
when you press
OGM1
or
OGM2
, the
TAD announces “You have no an-
nouncement one” (or “two”) and sounds
four beeps.
nouncement one” (or “two”) and sounds
four beeps.
SETTING THE TAD TO
ANSWER CALLS
ANSWER CALLS
To turn on the TAD and set it to answer
calls and record messages, press
calls and record messages, press
AN-
SWER
once. The TAD says “Answer on”,
and beeps once.
ANS
ON
appears, then
the TAD plays the outgoing message
and shows
and shows
OGM1
PLAYING
briefly.
43-704.fm Page 10 Wednesday, November 17, 1999 4:47 PM