Radio Shack TAD-704 Manuel D’Utilisation

14

Listen to the caller's message through
the TAD's speaker. To adjust the vol-
ume, slide 

 on the right side of

the TAD.

If you decide to answer the call, pick up
any phone on the same phone line as
the TAD. The TAD stops recording and
resets to answer the next call.

If you do not want to take the call, simply
let the TAD finish recording the caller's
message.

Note: If you answer the phone just as
the TAD answers, the TAD might not
stop playing the outgoing message. If
this happens, press 

 on the TAD.

If you screen your calls but want to know
when calls come in from certain people,
give them your Call Breakthrough (CBT)
Code.

When a caller enters the CBT code dur-
ing the outgoing message, the TAD
alerts you with a series of loud beeps for
35 seconds. To answer the call, pick up
the handset. If you do not answer, the
caller can leave a message after the
outgoing message plays.

The CBT code is preset to 168, but you
can change it by following these steps.

Note: If you do not complete each step
within 8 seconds, the TAD exits setup.
Start again from Step 1.

1. Hold down 

 until the TAD

beeps once.

2. Press 

 four times. 168

and 

 

 

 appear. 

flashes.

3. Repeatedly press 

 to set the

first digit, then press 

. The sec-

ond digit flashes.

Note: If you make a mistake,
repeatedly press 

 until the

desired digit flashes then re-enter
the code.

4. Repeat Step 3 to set the second and

the third digits.

5. Press 

 then press 

to return to the time display.

The TAD's remote operation security
code is preset to 704, but you can
change it by following these steps.

Note: If you do not complete each step
within 8 seconds, the TAD exits setup.
Start again from Step 1.

43-704.fm  Page 14  Wednesday, November 17, 1999  4:47 PM