Lorex Technology LH340 EDGE3 Manuel D’Utilisation

70

PC and Mac Client Software for Remote Viewing

Click Apply to save your settings or click Clear to exit without saving.

To ensure your DDNS settings are saved on your system, disconnect the power adapter from 
the rear panel of your system. Allow the system to power down for 15~20 seconds. Reconnect 
the power adapter.

NOTE: Please allow 10~15 minutes for the DDNS servers to update with your new DDNS 

address. This is normal for the DDNS system.

NOTE: You will have to reconfigure your DVR’s connection settings in DVR List to connect 

to the DVR using DDNS. For instructions, see “Changing DVR Settings” on page 65.

System tab

By default, Setup Mode opens to the System 
tab. However, you can view this screen at any 
time when navigating Setup Mode.

• Click the System tab from Setup Mode. The 

System Status screen appears.

NOTE: You cannot edit the IP address or port number.

Use the Mail tab to configure email alerts for triggered events (such as when motion is 
detected by one of the cameras) on your DVR. By default, email alerts use Lorex’s email 
server (recommended). However, you can also use your own SMTP server.

Email tab

To setup email alerts, you must be logged into 
your DVR using Edge Client Software. Once you 
are logged in, click 

 and then 

 to 

access the Email tab.

You must enable motion detection on your 
cameras to receive email alerts. For 
instructions, see “Enabling / Disabling Motion 
Detection” on page 40.

Click the Mail tab from Setup Mode.

Under Send Mail Status, select Default.

Under the Sender’s Email field, enter the sender’s email address.