Napco Security Technologies 825HS Manuel D’Utilisation

Keys

Key 1: TEST

Momentarily sounds the burglar

alarm from the battery. If no alarm
is heard, or if it is weak, the battery
may need replacing. Use this test
weekly. (To perform this function

the key must be held down until a

beep is heard.)

Key 2: ALARM HISTORY

This will flash the red ARMED/

MEMORY light to indicate the last
alarm condition. Count the number

 of flashes to determine the zones

violated. This feature does not
reset; after the system is rearmed,
the previous alarm history will remain

in alarm memory until automatically
reset by a new alarm condition. To
perform this function the key must
be held down until a beep is heard,
and then continued to be held down
until all information has been
displayed.

Key 3: STATUS INDICATION

RESET

This will stop the green STATUS

light flashing. To turn STATUS flash-
irig back on, hold down Key 3
aaain. (To oerform this function the
key must be held down until a beep
is heard.)
Key 4: INSTANT PROTECTION

Cancels the exit/entry delay

periods when arming. The delay is
restored after you disarm the system.
See page 10. (To perform this func-

tion the key must be held down until
a beep is heard.)

Key 5: DOOR CHIME

This will initiate a feature that

sounds a chime In the keypad each
time the entry door on zone 1 is
opened. This feature only works when
the alarm system is disarmed (off). To
eliminate  the door chime feature,
press this key again. A lengthy
“chime” may be reset using Key 9
(MA-825HS only). (To perform these
functions, the key must be held down
until a beep is heard.)

Key 9: RESET

Used to reset a Dav Zone Mini-

Sounder indication (MA-825HS only), a
lengthy door “chime” (MA-825HS
only). or the AC Failure indication (all

 

three indicatora flashing), and to
bypass

 a 

troubled zone deaignated as

a “Priority with Bypass Zone.” (To
reset any function, the key must be
held down until

beep is heard.)

Key S: SHUNT

This will flash the vellow SHUNT

light to indicate the zone(s)
shunted. Count the number of

flashes to determine the zone(s)
shunted.

To perform this function the key

must be held down until a beep is
heard, and continued to be held

down until all information has been
displayed. The key does not have
to be held down for either the
Selective Zone Shunting feature
(see page 10) or when selecting a
new code (see page 7).

Keys * and #: PANIC BUTTONS

Activates the panic zone. Refer to

“Panic Zone”, page 10 for more
information.