APC NBRK0570 Manuel D’Utilisation

The following controls appear in the Advanced tab:

Use the Status tab to view the status of your PPP connection, or to request an immediate dial-out to 
establish a PPP connection if none exists. Click Request Immediate Dial-Out to establish a connection. 
Once initiated, the PPP connection stays active until you click Cancel Dial-Up Request or the appliance 
reboots.

Dial-out response to alerts/reports Select the PPP dial-up action taken by the appliance when alerts or 

periodic reports are generated. Select from the following list:
• Disabled—No dial-up action is taken when alerts or reports are 

generated.

• Enabled—Use PPP to connect to the network whenever an alert or 

report is generated. Note: If the alert does not require a PPP 
connection, no connection will be made.

• Delivery Failure—Use PPP to connect to the network only if 

network-based alert notification (for example, e-mail, FTP, HTTP 
posting) or report delivery fails.

Remain connected after alerts/
reports sent

The number of minutes the appliance keeps the PPP connection active 
after connecting to the network to deliver alert or report information. 

LCP - Send LCP echo requests to 
peer

When checked, your appliance sends LCP echo requests, telling PPP 
that the PPP link is active even when there is no network traffic.

Exclusive route - Route all data 
through PPP when dialed-out

If selected, all data is routed through the PPP interface during PPP 
dial-out sessions. 

When cleared, the Ethernet interface communicates with hosts on the 
same subnet as the appliance. All communication with hosts that are not 
on the same subnet as the appliance uses the PPP interface.

Debug - Send debug messages to 
syslog

When selected, debug messages are forwarded to the Syslog host 
specified using the Log icon.

For more information, see “Log” on page 86.

SIM PIN / Confirm SIM PIN

For modems that use a subscriber identification module (SIM), specify 
the PIN used to unlock the SIM.

: A SIM may not require a PIN. For modems that do not have a 

SIM, this field must be blank.

Extra Initialization Commands

If necessary, type additional initialization commands to append to the 
commands noted in the Initialization commands field.

Use default modem commands

Select to use the default modem initialization string for your modem.

Initialization commands

If necessary, edit the initialization string for your modem.

E-mail Addresses for IP address 
Notification

When a PPP connection is established, an e-mail containing the IP 
address of the appliance is sent to all e-mail addresses in this field. To 
add addresses to this field, click Add, type an address in the E-mail 
Address field, and click OK.