Avaya 03-300430 Manuel D’Utilisation

This test is nondestructive.
The SNI circuit pack reports whether a fiber out-of-frame condition exists, whether a 
loss-of-signal condition exists, and whether the lightwave transceiver is present.

FAIL

The SNI circuit pack reported failures or retransmitted a cleared failure 
message.

1. If this is the first time this test was run, run the test again. If there were 

any previous failure messages that software did not acknowledge, this 
test will FAIL even if the failure messages indicate a FAIL to PASS 
transition, i.e., a problem has gone away. If this test is run twice and 
FAILs both times, then at least one problem still exists.

2. Resolve any errors or alarms (display errors and display 

alarms) for SNI-BD, SNI-PEER, and FIBER-LK entries.

3. If no SNI-BD, SNI-PEER, or FIBER-LK entries exist in the error and 

alarm logs, retry the command.

PASS

No problems are detected on the board.

 2 of 2

1415

ABRT

The lightwave transceiver is absent from Endpoint 1 of the fiber link. Use 
list fiber-link to display fiber link endpoints.

1. If a lightwave transceiver should not be present (for example, an SNI 

connected to a DS1 converter circuit pack), do nothing.

2. Otherwise, continue with the following steps.

3. Check the lightwave transceiver connections.

4. Replace the lightwave transceiver.

5. Replace the SNI circuit pack.

 1 of 9