Bosch DVA-16K Manuel D’Utilisation

en | Subsystem Maintenance

RAID Subsystem DVA-16K | Installation Manual

F.01U.027.799 | V2 | 2008.08

Bosch Security System

The subsystem comes with a pre-installed 256MB capacity or above DDR RAM DIMM module 

on the controller. The controller supports memory up to 1GB. If a DDR RAM DIMM module has 

failed or a different size of DIMM module needs to be used, the pre-installed module must be 

removed and the new one installed. Replacement and installation instructions are described 

fully below. 

If the memory module on the controller module is going to be replaced, the following issues 

must be considered when purchasing a replacement DIMM module:

•

Pre-installed DDR RAM DIMM module: The RAID subsystem comes with a 256MB capacity 

or above DDR RAM DIMM pre-installed on the controller board and can support up to 

1GB capacity. If you wish to change the size of the DDR DIMM, then a new DIMM must be 

installed.

•

Purchasing considerations: When purchasing a DDR RAM DIMM module to install on the 

RAID subsystem controller board, contact your subsystem vendor for an updated list of 

compatible DIMM modules.

•

DDR RAM DIMM module supported: The RAID subsystem supports DDR RAM DIMM mod-

ules with memory capacities between 256MB and 1GB.

•

Installation considerations: When installing the DDR RAM DIMM module, it is necessary to 

remove the controller module. The controller board is more susceptible to damage than 

the other components and must be handled with extreme care. 

•

Secure installation: When replacing the DIMM module, make sure that the new DIMM 

module is firmly in place prior to re-installing the controller module. If the DIMM module 

is not firmly in place, the subsystem will not run and the whole procedure must be 

repeated.

If a DIMM module fails or if a DIMM module with a higher memory capacity is required, the 

onboard DIMM module must be replaced. To replace the DIMM module:

1.

Remove the controller module. (See Section 6.2.2 Removing the Controller Module)

2.

Remove the previously installed DIMM module from the DIMM socket. Pull down the 

white clips on either side of the DIMM module to a 45-degree angle to dislodge the DIMM 

module. (See Figure 6.6)

Removing the DIMM Module

If you are going to replace or upgrade a DIMM module, please follow the instructions below. If 

you do not want to replace or upgrade a DIMM module and would like to install a controller 

module, please go to Section 6.2.3 Replacing the Controller Module.

 

White Clip

White Clip 

White Clip

White Clip