Bosch DVA-16K Manuel D’Utilisation

en | Warnings and Certifications

RAID Subsystem DVA-16K | Installation Manual

F.01U.027.799 | V2 | 2008.08

Bosch Security System

•

A shielded power cord is required in order to meet FCC emission limits and also to pre-

vent interference with nearby radio and television reception.

•

Use only shielded cables to connect I/O devices to this equipment. You are cautioned 

that changes or modifications not expressly approved by the party responsible for com-

pliance could void your authority to operate the equipment.

•

Prior to powering on the subsystem, ensure that the correct power range is being used.

•

The subsystem comes with 16 drive bays. Leaving any of these drive bays empty will 

greatly affect the efficiency of the airflow within the enclosure, and will consequently 

lead to the system overheating, which can cause irreparable damage.

•

If a module fails, leave it in place until you have a replacement unit and you are ready to 

replace it.

•

Airflow Consideration: The subsystem requires an airflow clearance, especially at the 

front and rear.

•

Handle subsystem modules using the retention screws, eject levers, and the metal 

frames/face plates. Avoid touching PCB boards and connector pins.

•

To comply with safety, emission, or thermal requirements, none of the covers or replace-

able modules should be removed. Make sure that all enclosure modules and covers are 

securely in place during operation.

•

Be sure that the rack cabinet into which the subsystem chassis will be installed provides 

sufficient ventilation channels and airflow circulation around the subsystem.

•

Provide a soft, clean surface to place your subsystem on before working on it. Servicing 

on a rough surface may damage the exterior of the chassis.

•

If it is necessary to transport the subsystem, repackage all drives and replaceable mod-

ules separately.

•

Dual redundant controller models come with two controller modules that must be 

installed into the subsystem. Single controller modules come with a single controller 

module and a metal sheet is placed over the lower controller bay at the rear of the sub-

system. Since single controller modules cannot be upgraded, this metal sheet should 

NEVER be removed.

Observe all conventional anti-ESD methods while handling system modules. The use of a 

grounded wrist strap and an anti-static work pad are recommended. Avoid dust and debris in 

your work area.