Intel DG43RK LGA-775 socket DDR3 1333/1066 MHz 8GB BOXDG43RK Manuel D’Utilisation
Codes de produits
BOXDG43RK
Intel Desktop Board DG43RK Technical Product Specification
44
2.2
Connectors and Headers
CAUTION
Only the following connectors have overcurrent protection: Back panel and front panel
USB, PS/2, and IEEE 1394a.
USB, PS/2, and IEEE 1394a.
The other internal connectors/headers are not overcurrent protected and should
connect only to devices inside the computer’s chassis, such as fans and internal
peripherals. Do not use these connectors/headers to power devices external to the
computer’s chassis. A fault in the load presented by the external devices could cause
damage to the computer, the power cable, and the external devices themselves.
Furthermore, improper connection of USB or IEEE 1394 header single wire connectors
connect only to devices inside the computer’s chassis, such as fans and internal
peripherals. Do not use these connectors/headers to power devices external to the
computer’s chassis. A fault in the load presented by the external devices could cause
damage to the computer, the power cable, and the external devices themselves.
Furthermore, improper connection of USB or IEEE 1394 header single wire connectors
may eventually overload the overcurrent protection and cause damage to the board.
NOTE
Computer systems that have an unshielded cable attached to a USB port may not
meet FCC Class B requirements, even if no device is attached to the cable. Use a
shielded cable that meets the requirements for full-speed devices.
meet FCC Class B requirements, even if no device is attached to the cable. Use a
shielded cable that meets the requirements for full-speed devices.
This section describes the board’s connectors and headers. The connectors and
headers can be divided into these groups:
• Back panel I/O connectors (see page 45)
• Component-side connectors and headers (see page 46)
headers can be divided into these groups:
• Back panel I/O connectors (see page 45)
• Component-side connectors and headers (see page 46)