Empire Comfort Systems VFSUR24-2 Manuel D’Utilisation

Page de 24
25741-0-0309
Page 6
Important
All correspondence should refer to complete Model Number, Serial 
Number and type of gas.
Attention: during initial use of log you will detect an odor as 
the log is cured. 
Notice:
 During initial firing of this unit, its paint will bake out, and 
smoke will occur. To prevent triggering of smoke alarms, ventilate 
the room in which the unit is installed.
wArNING: This appliance is for installation only in a solid-
fuel burning masonry or UL 127 factory-built fireplace or in a 
listed ventless firebox enclosure. It has been design certified for 
these installations. exception: do NoT install this appliance 
in a factory-built fireplace that includes instructions stating 
it has not been tested or should not be used with unvented 
gas logs.
WARNING: Any modification to this unvented gas heater or 
its controls can be dangerous. Improper installation or use of 
the heater can cause serious injury or death from fire, burns, 
explosion or carbon monoxide poisoning.
Well Head Gas Installations
Some natural gas utilities use "well head" gas. This may affect the 
Btu output of the unit. Contact the gas company for the heating 
value.  Contact  the  manufacturer  or  your  gas  company  before 
changing spud/orifice size.
IMPoRTANT: Read all instructions carefully before starting 
installation. failure to follow these installation instructions may 
result in a possible fire hazard and will void the warranty.
Save this manual for future reference.
Please  read  this  manual  before  installing  and  using  the 
appliance.
Instructions to Installer
1.  Installer  must  leave  instruction  manual  with  owner  after 
installation.
2.  Installer must have owner fill out and mail warranty card supplied 
with unvented room heater/vented decorative appliance.
3.  Installer should show owner how to start and operate unvented 
room heater/vented decorative appliance.
Always  consult  your  local  Building  Department  regarding 
regulations, codes or ordinances which apply to the installation of 
an unvented room heater/vented decorative appliance.
This appliance may be installed in an aftermarket* manufactured 
(mobile) home, where not prohibited by state or local codes.
*Aftermarket: Completion of sale, not for purpose of resale, from 
the manufacturer.
This appliance is only for use with the type of gas indicated on the 
rating plate. This appliance is not convertible for use with other 
gases.
New Installation
Solid-fuels  shall  not  be  burned  in  a  fireplace  where  a  vented 
decorative appliance is installed.
A vented decorative appliance must be installed only in a solid-
fuel burning fireplace with a working flue and constructed of non-
combustible material.
Any alteration of the original design, installed other than as 
shown in these instructions or use with a type of gas not shown on 
the rating plate is the responsibility of the person and company 
making the change.
AcceSSOrIeS
Description
Color
EK-2
Embers Kit
ELH-1
Fireplace Hood for Vent-Free Logs
Black
ELH-2
Fireplace Hood for Vent-Free Logs
Brass
FRBC
Battery Operated Remote Control - Manual
FRBTC
Battery Operated Remote Control with Thermostat 
FREC
Electric Remote Control - Manual
FWS
Wall Switch
TMV 
Wall Thermostat, Millivolt - Reed Switch
INTrODucTION
Model
Gas
Valve Type
BTuH
Max. Rate
BTuH
Min. Rate
VFSUR18
Natural
Millivolt
36,000
25,000
VFSUR18
Propane
Millivolt
36,000
25,000
VFSUR24
Natural
Millivolt
38,000
26,500
VFSUR24
Propane
Millivolt
38,000
26,500
VFSUR30
Natural
Millivolt
40,000
28,000
VFSUR30
Propane
Millivolt
40,000
28,000
PRoducT SPecIfIcATIoNS
Natural Gas
Propane Gas
Valve Type
Millivolt
Millivolt
Regulator pressure setting
3.5" W.C.
10.0" W.C.
Gas inlet pressure
Max.
10.5" W.C.
13.0" W.C.
Min.
5.0" W.C.
11.0" W.C.