Emerson CF770OB02 Manuel D’Utilisation

1. Check to see that you have received the following

parts:

NOTE: If you are uncertain of part description,
refer to exploded view illustration.

a. Fan motor assembly
b. One switch housing assembly
c. Five fan blades
d. One ceiling cover
e. Five blade flanges
f. One hanger ball/downrod assembly
g. One hanger bracket
h. One coupling cover
i. One loose parts bag containing:

1. Sixteen M5 x 6 slotted Phillips washer

head blade screws

2. One M6 x 14 flange screw with

lockwasher

3. One wood ball
4. Three wire connectors
5. Two threaded studs
6. Two lockwashers
7. Two knurled knobs
8. One clevis pin

This Manual Is Designed to Make it as Easy as

Possible for You to Assemble, Install,

Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver

One stepladder

One 1/4” blade screwdriver

One wire stripper

One 5/16” open end wrench, or pliers
Three wire connectors (supplied).

MATERIALS

Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would
be a 3-conductor (2-wire with ground) of following
size:

Installed Wire Length

Wire Size A.W.G.

Up to 50 ft.

50-100 ft.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is com-
pleted, place a check mark in the box. This will insure that all steps have been completed
and will be helpful in finding your place should you be interrupted.

9. One hairpin clip

10. One coupling
11. Sixteen blade washers

NOTE: Place the parts from the loose parts bags
in a small container to keep them from being lost.
If any parts are missing, contact your local
retailer or catalog outlet for replacement before
proceeding.

2. Remove the fan assembly from the protective

plastic bag. Place the fan assembly into the upper
foam pad with the top of the motor facing up.
The upper foam pad serves as a holder for the fan
during the first stages of assembly.

FAN MOTOR
ASSEMBLY

CARTON

LOWER
FOAM PAD

SWITCH
HOUSING
ASSEMBLY

LOOSE PARTS
BAG

HANGER BALL/
DOWNROD ASSEMBLY

CEILING
COVER

HANGER
BRACKET

BLADE
FLANGES

PROTECTIVE
PLASTIC BAG

UPPER
FOAM PAD

FAN BLADES

COUPLING
COVER

Before assembly your ceiling fan, refer to section on
proper method of wiring your fan (page 6). If you feel
you do not have enough wiring knowledge or experi-
ence, have your fan installed by a licensed electrician.

WARNING

Do not install or use fan if any part is damaged or
missing. Call Toll-Free:

1-800-654-3545

This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson could result in personal injury or
property damage.

WARNING