Ives 7253 Fascicule

Improper pivot set installation can lead to personal injury or property damage. Follow

all instructions carefully. For questions contact Technical Support at 1-888-371-7331.

1. Prepare and mortise bottom of door and floor to receive pivot set. Determine pivot location

using dimensions on reverse side. Depth of mortise in bottom of door will determine clearance.
Be sure to properly locate and mark pivot center point of the base plate.

2. Locate, drill, and tap 1/4-20 mounting holes for metal door. Locate and drill pilot holes for

#14 wood screws for wood door. Mount door leaf in bottom of door with 1/4-20 x 3/4” FHMS
or #14 FHWS screws provided.

3. Drill 3/4” dia. x 1-3/4” deep hole in floor on center of pivot point for base plate mounting.

Pivot point of top pivot set must be plumb with bottom pivot point. Insert anchor pin
into hole and expand with tool. Insert base plate screw provided. Grout anchor pin in place.
After grout has set, remove base plate screw.

4. Place base plate over anchor pin. Fasten to floor with base plate screw. Tighten securely.

5. If using a threshold, install threshold at this time.

6. Install top pivot set and hang door. Refer to top pivot set instructions.

7. If vertical height adjustment is necessary, use shims between door bottom and pivot leaf to

increase clearance. To decrease clearance, mortise in door must be made deeper.

Anchor pin

Base plate

Base plate screw

Door leaf