Casablanca Fan Company 59064 Manuel D’Utilisation

www.CasablancaFanCo.com

1.888.227.2178

M8502-01 • 04/16/15 • © 2013–2015 Casablanca Fan Company

•  Tighten all of the blade 

screws until they are snug.

•  Turn the power off, support 

the fan carefully, and check 
that the hanger ball is 
properly seated.

•  Use the provided balancing 

kit and instructions to balance 
the fan.

•  Tighten the blade screws until 

they are snug.

•  Check to see if any of the 

blades are cracked. If so, replace 
all of the blades.

•  Press a fan speed button (1-4).

•  Check the circuit breaker to 

ensure the power is turned on.

•  Check the wall control battery.

•  Make sure the blades spin freely.

•  Turn off power from the circuit 

breaker, then loosen the canopy 
and check all the connections 
according to the wiring diagram 
on pages 9-10.

•  Check the plug connection in 

the switch housing.

•  Make sure the wattage of 

the light bulbs installed 
matches the specifications 
on the light sockets. (see 
page 18 for instructions on 
changing the bulbs).

•  Make sure the battery is installed 

correctly.

•  Install a new battery.

•  If the remote still does not 

work, you may need to pair 
your remote. To prevent faulty 
operation, please disconnect 
power (at the wall switch, 
breaker, or fan) from all other 
ceiling fans within range while 
pairing. To pair: cycle power 
to the fan by turning power off 
and back on at the wall switch 
(or circuit breaker if necessary). 
Within three minutes, press and 
hold both the Fan Off button and 
the 4 button for four seconds to 
pair the remote. If applicable, the 
fan will turn on and the lights 
will flash and stay on to indicate 
successful pairing.

For the most updated list of 
Casablanca Authorized Service 
Centers, visit 
www.CasablancaFanCo.com or 
call toll free 1-888-227-2178.

•  To enable dimming, you 

must first set your remote to 
Dimming Mode. To toggle 
Dimming Mode on or off, hold 
down the Fan Power button 
while pressing the Light Down 
arrow twice.

•  Ensure each bulb you are using 

supports dimming.