Roberts Gorden UHD[X][S][R] 225 Manuel D’Utilisation

27

Check for gas leaks.

See Page 16, Section 8.

Make sure it is clean and free of cracks or holes.

Clean and replace as required.

Compressed air or a vacuum cleaner may be used to clean dust and dirt.

Clear obstructions (even spider webs will cause problems).

Carefully remove any dust and debris from the burner.

Replace if there are cracked ceramics, excessive carbon residue, or erosion 
of the electrode.

The electrode gap should be 1/8" (3.2 mm).

There should be no exposed wire or damage to the device or wiring.

See Page 17, Section 9.

Make sure the heater is hanging securely. 

Look for signs of wear on the suspension materials or ceiling.

See Page 8, Figure 3.

Ensure tight, secure fit on all pressure fittings at pressure switch, 
burner partition, and blower outlet.

Verify that cap covering pressure regulator adjustment screw is secure and 
has not been tampered with.

Verify all wiring connections.

Flush drain and clear any obstructions.

Consult an indoor air quality professional for proper cleaning procedures

For a complete inspection, refer the manufacturers Installation, Operation and 
Service manual.

If wall tag is present, make sure it is legible and accurate. Please contact 
Roberts-Gordon LLC or your ROBERTS-GORDON

®

 independent distributor if 

you need a wall tag. See Page 2, Section 2.1.