GTO SL-2000B Manuel De Montage
1
IMPORTANT SAFETY INSTRUCTIONS
Because automatic gate operators produce high levels of force, all system designers, installers, and consumers
have an obligation to know the potential hazards associated with improperly designed, installed, or maintained gate
operator systems. Keep in mind that the gate operator is just one component of the total gate operating system.
Each component must work in unison to provide the consumer with convenience, security, and safety.
This manual contains various safety precautions and warnings for the system designer, installer, and consumer.
Because there are many possible applications of the gate operator, the safety precautions and warnings contained in
this manual cannot be completely exhaustive in nature. They do, however, provide an overview of the safe design,
installation, and use of this product. CAREFULLY READ AND FOLLOW ALL SAFETY PRECAUTIONS,
WARNINGS, AND INSTALLATION INSTRUCTIONS TO ENSURE THE SAFE SYSTEM DESIGN,
INSTALLATION, AND USE OF THIS PRODUCT.
The precautions and warnings in this manual are identified with this
warning symbol.
The
symbol identifies the conditions that can result in damage to the operator or its components, serious
injury, or death.
Because GTO automatic gate operators are only part of a total gate operating system, it is the responsibility
of the designer, installer, and purchaser to ensure the total system is safe for its intended use. Bypassing
safety devices or neglecting to use safety devices with the gate operator is NOT acceptable.
FOR THE GTO/PRO SL-1000/2000
AND
GTO/PRO SL-1000B/2000B
AUTOMATIC SLIDE GATE OPERATORS
Quick Release Pin (211IH)
Chain Bracket (204IH)
TO MANUALLY OPEN AND CLOSE THE GATE, FOLLOW
THE PROCEDURE BELOW:
THE PROCEDURE BELOW:
CAUTION: Disconnect the
operator chain ONLY when the
gate is NOT moving.
gate is NOT moving.
1. Lift the quick release pins UP, then
pull them OUT of the chain brackets
(see illustration).
2. Lay the chain down and manually slide
the gate to the desired position.
pull them OUT of the chain brackets
(see illustration).
2. Lay the chain down and manually slide
the gate to the desired position.
To prevent unauthorized removal of the
quick release pins, install pin locks (see
accessory catalog
quick release pins, install pin locks (see
accessory catalog
) above the quick release
pins in both chain brackets.