Bacharach INSIGHT Manuel D’Utilisation

28

29

Power OFF the analyzer by pressing the PWR button 

for at least 2 seconds, or until two beeps are heard.  The 

unit will count down 5 seconds before shutting down, 

giving the operator an opportunity to keep the analyzer 

powered ON by pressing the RUN/HOLD button.

If the analyzer was not purged with fresh air then the analyzer may remain 

ON with its pump running and display the message "PURGING SENSORS" 

as the result of combustion gases still being present inside the analyzer.  At 

this time the operator should ensure that the probe is removed from the stack, 

allowing the analyzer to purge itself with fresh air.  The 5-second-shutdown 

sequence will not begin until the gas levels inside the analyzer drop below 

predeterminded levels.

  Although not recommended, the purging process can be bypassed 

by pressing the PWR button a second time.

When the batteries are nearly depleted, an empty battery icon appears in 

the upper-right corner of the display, and a short beep is sounded every 10 

seconds.

After a low battery alarm occurs, the analyzer will continue to operate for 

only a few minutes.  The amount of operating time that remains depends 

on many factors (e.g. pump and backlight being ON or OFF and the type 

and condition of the batteries).

All saved data can be retrieved for viewing through the MEMORY option.

1. Display the MAIN MENU by pressing the MENU (F2) button.  If 

necessary, press ESC until MENU appears above F2.

2. Use the ▲▼ buttons to select MEMORY.  

Press ENTER to display the MEMORY 

MENU.

3. Use the ▲▼ buttons to select Memory Direc-

tory.  Press ENTER to display the saved data 

contained in the Memory Directory.

page through the screens by pressing the 
PAGE– (F1)

 and PAGE+ (F3) buttons. Or 

pressing the     buttons, respectively.

1. Display the MAIN MENU by pressing the 

 button.  If necessary, press ESC 

until MENU appears above F2.

2. Use the ▲▼ buttons to select MEMORY.  

Press ENTER to display the Memory Screen.

3. Use the ▲▼ buttons to select CLEAR 

MEMORY.  Press ENTER to display the 

Clear Memory Options.

4. Use the ▲▼ buttons to select YES and press 

.  The screen will briefly display a 

confirmation that the memory has been 

cleared.