Regency B36X Manuel D’Utilisation

Regency Bellavista™ B36X Gas Fireplace

10) Remove the 8 Phillips head screws securing 

the valve tray assembly in place (Diagram 
6) and then lift the entire assembly out 
(Diagram 7).

1)  Shut off the gas supply.

2)  Remove the louvers 

3) Open the fl ush door and remove the door.
 

(See Pg. 47 for instructions)

4)  Remove the logs.

5)  Remove the burner/grate assembly by 
      removing the 2 Phillips head screws.

7)  Remove the 2 screws securing the rear log 

tray and lift out. Diagram 3

9)  Disconnect the wall switch wires from the 

valve. (see Diagram 5)

1)  Place new valve tray into position

2)  Reinstall the 8 hold down screws.

3)  Hook up the 2 TP and 2 TH wires to the ap-

propriate connections on the valve.

4)  Reinstall the rear log tray.

5)  Install Burner/grate assembly

6)  Hook up the gas line and check for gas leaks 

with a soap and water solution or a gas leak 
detector. (Do not use open fl ame for leak 
testing.)

7)  Fire up the unit temporarily

8)  Check the manifold pressure.

9)  Reinstall the logs and brick panels as 

needed.

10) Reinstall the door and replace the louvers.

11) Fire up the unit again and check for proper 

fl ame appearance and glow on logs.

6)  Slide the burner assembly to the left to release 

it from the orifi ce, then lift it out.

8)  Disconnect the inlet gas line. 
      (see Diagram 4)