Quadra-Fire SANTAFEI-CE-MBK Manuel D’Utilisation

Page 10

October 27, 2011

R 

7069-101B

A properly adjusted fire with the heat output control button

set on “HIGH” has a short active flame pattern that extends

out of the firepot approximately 102mm.
If the fire has tall flames with black tails and seems somewhat

lazy, the feed rate will need to be reduced.
If the fire is not 102mm tall, increase the feed rate. A medium

and low setting will give a shorter flame. The flame will rise

and fall somewhat. This is normal.

The feed adjustment control rod is factory set, and should be

adequate for most fuels. The control rod will slide by only

loosening the wing screw.
However, if the flame height is too high or too low, you will

need to adjust the feed rate. Wait until the appliance has been

burning for 15 minutes before making your adjustments and

allow 15 minutes for feed adjustment to take effect. Make

adjustments in approximately 12.7mm increments.
1.  Loosen the wing screw.

2.  Adjust the fuel adjustment control rod towards to the right

and up to increase the feed rate and flame height or to

the left and down to decrease the feed rate and flame

height.

3.  Re-tighten the wing screw.

1.  A  thermostat  is  required  for  proper  operation  of  this

appliance. At this time, fill the hopper with pellets, set

the thermostat to its lowest setting. Plug the power cord

into nearby outlet.

2.  The  exhaust  blower  will  stay  on  for  approximately  18

minutes  even  though  the  thermostat  is  not  calling  for

heat. This is normal.

3.  Locate the heat output control switch on the lower right

side of the firebox behind decorative front door. Set to the

HIGH setting and then adjust the thermostat to its highest

setting. The red call light will be on which is located on

the top of the junction box behind the right access panel.

This indicates the thermostat is calling for heat.

10.1.

4.  The fuel feed system and the igniter should now be on.
5.  For your first fire it will be necessary to press the reset

button once per minute until pellets start to drop into the

firepot, then press button 1 more time. This will fill the

feed system and allow the appliance to begin dropping

pellets. The appliance will continue to run as long as the

thermostat is calling for heat.

6.  Once the appliance has ignited, let it burn for approximately

15 minutes, then set the thermostat to the desired room

temperature. Adjust the heat output control switch to the

desired setting.

Odors and vapors released during initial operation.

•  Curing of high temperature paint.

•  Open windows for air circulation.

Odors may be irritating to sensitive individuals.

Control Box

Junction Box 

Reset Button

Heat Output 

Switch 

Power Cord 

Outlet 

Thermostat

Block

Fuse

Red Call

Light

Red/Green/Amber Light

Blue Light 

Firepot Cleaning Rod