Dansons Group IPP Bay View Insert / Built-In Manuel D’Utilisation

 

Can

adian Comfort Industries      V04                                            

31                                                        

 PELPRO OWNERS MANUAL 

Copyright 2004                                                                     

Dansons Group Inc.

 

 

To clean the grate, pull rod on front of stove back and forth a few times, once or twice per day.  

IMPORTANT: Be sure you PUSH the rod in fully for normal operation. 

 

The burn grate top, (G), must fit and seal firmly on the upper lips, (H), of the burn box, (A).  An improper seal will 
allow incoming combustion air to escape, not passing up through the burn grate thus reducing the amount of 
combustion air in the area needed to efficiently burn pellets. 

 

 
A
B 
 
C
D
E
F 
G 
H 

 
- Burn box 
- Burn grate spacer, 
   (follower) 
- Pin, securing spacer to rod 
- EZ-Clean pull rod 
- Burn grate bottom 
- Adjustment tab, burn grate 
- Burn Grate top  
- Upper Lips 
 
 
 
 
 

 

 

 
 
 
 
Adjusting the burn grate:  

Steps in adjusting the burn grate top so the lower end of the burn 
grate top sits firmly on the top of the burn grate bottom, (E),  

 

 
 
Removal of burn grate top:  

Lift upward (1) while sliding lip out from under                                   
lip of slide (2) then pull out toward outside of 
burn box (3)  
Installation is reverse of this. 

 
 

 
 

Grasp the  burn grate adjustment tab (F), with a pair of pliers and bend it slightly to left or 
right  (and re-install  into burn box) until its length allows the burn grate top to rest tightly 
onto the burn grate bottom. (Location J)