DeLonghi WE 115 Manuel D’Utilisation

19

Power supply voltage

Maximum absorbed power
in air conditioning

Refrigerant 

Cooling capacity

see rating plate

“

“

“

Room temperature for air conditioning 70÷95 °F

(21÷35°C)
 

The  terms  of  the  guarantee  and  technical  assi-

stance  are  given  in  the  documentation  accom-

panying your appliance. 

Transport, filling, cleaning, recovery and disposal of refrigerant should be performed by a technical

service centre appointed by the manufacturer only.

The appliance should be disposed of by a specialist centre appointed by the manufacturer only.

NEVER TRANSPORT OR TURN THE APPLIANCE UPSIDE DOWN OR ON ITS SIDE. IF THIS OCCURS,

WAIT 6 HOURS BEFORE TURNING THE APPLIANCE ON, 24 HOURS IS RECOMMENDED. (After the

unit has been on its side, oil needs to return to the compressor to ensure proper function.  Without 

allowing the unit this time (6-24 hours) The unit may function for only a short time, and then the

compressor will break down from lack of oil). 

This appliance is equipped with a 3 prong grounded plug. The plug must be connected into an outlet

that is properly installed and grounded in the accordance with all local codes and ordinances. Do not

modify the plug provided with the appliance. If it will not fit the outlet, have a proper outlet installed

by a qualified electrician or relocate the unit to a proper outlet.

If the household electrical supply does not meet the above specifications, or if you are not sure your

home has an effective electrical ground, have a qualified electrician or your local electrical utility

company check it and correct any problems.

The appliance is fitted with a safety plug to protect the power cable.

If power is cut off, unplug from the outlet and make sure the power cable is undamaged.

If the cable is damaged, call the service center immediately.

If power cuts off frequently and the power cable is undamaged, contact a qualified electrician.

If the safety device incorporated in the plug trips and cuts off the power supply, check that the power 

cable and plug are not damaged.

If the power cable is undamaged, to restore operation press the “RESET” button.

To verify correct operation of the plug, press the “TEST” button periodically and make sure the ap-

pliance disconnects. If this is not the case, contact the service center.

To restore operation, press the “RESET” button.