Friedrich US10B10A Manuel D’Utilisation
USC Sleeve/Standard Grille
USC Sleeve/Replacement Grille*
stanDarD grille – expanded aluminum
For use with USC sleeve. (Ships with USC sleeve).
*replaCement grille – high-tech plastic
For use on existing sleeves without any grille. (Ships with
chassis).
chassis).
important note:
When installing into an existing sleeve, consult Installation
Section of your Installation/Operation Manual to determine
whether or not the grille needs to be replaced and/or a
baffle adapter should be used.
Section of your Installation/Operation Manual to determine
whether or not the grille needs to be replaced and/or a
baffle adapter should be used.
Installation Accessories (WallMaster only)
DK / Drain Kit
Installed at the back of the unit and allows
for attachment to permanent condensate
disposal system, if disposal is necessary
or desired.
SB / Sub Base
Used as a base for the unit when
it is desired to place the cord and
receptacle within the installation, or
simply as a base for the unit when
mounted low in the wall.
BAK / Baffle Adapter Kit
Necessary when installing in a sleeve
deeper than 16 3/4" deep, such as
Fedders B sleeve (19 3/4" deep).
IDK / Internal Drain Kit
New construction applications where
a condensate drain system has been
built into the wall interior.
16 3/4"
Fedders B
19 3/4”
important:
Operating the air conditioner
with incorrect rear grille or
without Baffle Adapter Kit
(on 19 3/4” deep sleeve) will
recirculate discharge air and
cause compressor overload
to trip.
with incorrect rear grille or
without Baffle Adapter Kit
(on 19 3/4” deep sleeve) will
recirculate discharge air and
cause compressor overload
to trip.
CORRECT Vertical Louvers
INCORRECT Horizontal Louvers
WSC Sleeve/Standard Grille WSC Sleeve/Optional Architectural Grille, AG
Model
Height
Width Depth
Depth
with
Front
Minimum
Extension
Into Room
Minimum
Extension
Outside
Thru-the-wall
Finished Hole
Height
Width
WALLMASTER
WSC Sleeve
Chassis
WSC Sleeve
Chassis
16 3/4"
27"
16 3/4"
23"
7 1/2"
9/16"
17 1/4"
27 1/4"
15 3/4" 26 1/2"
21"
–
–
–
–
–
UNI-FIT
USC Sleeve
USC Sleeve
15 1/2" 25 7/8"
16 3/4"
20 1/2"
–
1/2"
15 3/4"
26 1/8"
US Chassis
14 3/8"
24"
20 1/8"
3 3/4"
–
–
–
UE Chassis
14 3/8" 24 5/8"
19 5/8"
3 1/2"
–
–
–
important:
• Sleeves are sold and shipped separately to accommodate
new construction and replacement requirements
Sleeve/Chassis Dimensions
Exterior Grilles
Exterior Grilles