Toshiba RAV-SP1100AT-E Manuel D’Utilisation

54

1000 

or more

300 

or more

1500

 or more

2000 

or more

200 

or more

300 

or more

300 

or more

1000 

or more

200 

or more

1000 

or more

1000  or more

1000  or more

150 

or more

Open the upper side and both right and left sides.
The height of obstacle at both front and rear side,
should be lower than the height of the outdoor unit.

1. Single unit installation

2. Serial installation of two or more units

Open the upper side and both right and left sides.
The height of obstacle at both front and rear sides
should be lower than the height of the outdoor unit.

600

150

150

430

365

40

400

Drain hole

Knockout hole

Drain nipple mounting hole

• Before installation, check strength and horizontality of

the base so that abnormal sound does not generate.

• According to the following base diagram, fix the base

firmly with the anchor bolts.
(Anchor bolt, nut: M10 x 4 pairs)

15 or less

Set the out margin of the anchor bolt to 15mm or less.

• In case of drainning through the drain hose, attach

the following drain nipple and the waterproof rubber
cap, and use the drain hose (Inner diam.: 16mm) sold
on the market. And also seal the screws securely with
silicone material, etc. so that water does not drop
down. Some conditions may cause dewing or drip-
ping of water.

Knockout hole

Waterproof rubber cap

Open

Drain nipple

• When there is a possibility of freezing of drain at the

cold district or a snowfall area, be careful for drainage
ability of drain. The drainage ability increases when a
knockout hole on the base plate is opened. (Open the
knockout hole to outside using a screwdriver, etc.)