Bryant 558F Manuel D’Utilisation
Copyright 2005 Bryant Heating & Cooling Systems
Printed in U.S.A.
CL-1
CATALOG NO. 04-53558002-01
CUT
A
L
O
N
G
DO
TTE
D LI
NE
C
U
T
A
L
ONG DO
TT
ED
L
INE
START-UP CHECKLIST
(Remove and Store in Job File)
I. PRELIMINARY INFORMATION
MODEL NO.: _______________________________________
DATE: _____________________________________________
SERIAL NO. _______________________________________
TECHNICIAN: _________________________________________
BUILDING LOCATION: ________________________________
II. PRE-START-UP (insert checkmark in box as each item is completed)
REMOVE COMPRESSOR TIEDOWN BANDS (SIZES 103,121,150,151 ONLY) PER INSTALLATION INSTRUCTIONS
VERIFY THAT CONDENSATE CONNECTION IS INSTALLED AS SHOWN IN THE INSTALLATION
INSTRUCTIONS
INSTRUCTIONS
CHECK ALL ELECTRICAL CONNECTIONS AND TERMINALS FOR TIGHTNESS
CHECK THAT INDOOR AIR FILTERS ARE CLEAN AND IN PLACE
VERIFY THAT UNIT INSTALLATION IS LEVEL WITHIN TOLERANCES LISTED IN THE
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
CHECK FAN WHEEL AND PROPELLER FOR LOCATION IN HOUSING/ORIFICE AND SETSCREW TIGHTNESS
CHECK PULLEY ALIGNMENT AND BELT TENSION; REFER TO INSTALLATION INSTRUCTIONS
VERIFY INSTALLATION OF ECONOMI$ER IV HOOD (IF EQUIPPED)
III. START-UP
ELECTRICAL
TEMPERATURES
BOTH CIRCUITS OPERATING
REFRIGERANT
VERIFY REFRIGERANT CHARGE USING COOLING CHARGING CHARTS ON PAGES 58-61
(COOLING MODE ONLY)
(COOLING MODE ONLY)
VERIFY 3-PHASE SCROLL COMPRESSOR IS ROTATING IN THE CORRECT DIRECTION
GENERAL
VERIFY ECONOMI$ER IV MINIMUM VENT POSITION AND CHANGEOVER SETTINGS ARE CONFIGURED
TO JOB REQUIREMENTS (IF EQUIPPED)
TO JOB REQUIREMENTS (IF EQUIPPED)
SUPPLY VOLTAGE
L1-L2
L2-L3
L3-L1
CIRCUIT NO. 1 COMPRESSOR AMPS
L1
L2
L3
CIRCUIT NO. 2 COMPRESSOR AMPS
L1
L2
L3
INDOOR FAN AMPS
L1
L2
L3
OUTDOOR-AIR TEMPERATURE
DB
RETURN-AIR TEMPERATURE
DB
WB
COOLING SUPPLY AIR
DB
WB
CIRCUIT NO. 1
CIRCUIT NO. 2
REFRIGERANT SUCTION
PSIG
PSIG
REFRIGERANT TEMPERATURE SUCTION
F
F
REFRIGERANT LIQUID LINE
PSIG
PSIG
REFRIGERANT TEMPERATURE LIQUID LINE
F
F