Regency C33-NG3 Manuel D’Utilisation

Regency

®

 CLASSIC C33-3 Freestanding Gas Stove

11

1) Gas 

on/off 

knob

2) Manual 

high/low 

adjustment

3) Pilot 

Adjustment

4) Thermocouple 

Connection

5) Main 

Operator

6)  Outlet Pressure Tap
7) Inlet 

Pressure 

Tap

8) Pilot 

Outlet

9)  Main Gas Outlet
10) Flange Securing Screw Holes
11) Alternative TC Connection Point
12) Thermoelectric Unit
13) Additional Valve Mounting Hole

1)  Attach the ground wire to the grounding 

stub.

4)  Loop the wires 

through the heat 

shield.

5)  Install the plastic bushing over the outside of 

the hole to protect the wires from the sharp 

edges.

6a) Attach the ground wire to the DC spark 

mounting bracket.

6b) Next, attach the DC sparker generator wires 

to the DC sparker.

2)  Loop the 2 DC Spark generating wires as 

well as the ground wire through the hole 

provided.

 

Select the hole to be used (depending 

on which side you prefer to install the DC 

Sparker box).

8)  Attach the heat shield to the DC Sparker, 

then mount onto either the Pedestal or the 

Bottom Shield, using the velcro already 
attached to the DC Sparker mounting 

bracket.

 

Note:  We recommend attaching the DC 

sparker box to the bottom rear of the unit 

(away from the heat source). Ensure this 

a convenient location, easily accessible for 

battery replacement.

3)  Attach the Piezo 

Ignition wire to 

the DC Sparker 

box.

7)  Install the supplied battery into the DC Sparker 

Box by opening the battery compartment.

 NOTE: The battery in the DC Sparker Box 

will need to be replaced annually.