Regency C33-NG3 Manuel D’Utilisation

20

Regency

®

 CLASSIC C33-3 Freestanding Gas Stove

8)  If optional fan is installed, remove thermodisc 

to bracket by removing three (3) phillips head 
M5 screws.

9)  Remove front cover with Piezo Igniter by 

removing two (2) sheet metal screws.

10) Loosen four (4) phillips head M5 valve 

mounting screws from underside of fi rebox. 
Push valve assembly forward on the teardrop 
slots and drop down. Diagram 3.

4)  Disconnect gas line to stove.

5)  Disconnect 3/8" NPT pipe from 90

o

 elbow 

on valve.

6)   Disconnect the two (2) switch wires from 

valve.

7)  Remove two (2) orifi ce bracket screws inside 

fi rebox.

1)  Shut off gas supply.

2)  If optional fan is installed, disconnect power 

source to stove.

3)  Remove access panel.

 a)  Front panel on pedestal model. See 

diagram 1.

 b)   Panel from bottom of leg shield.  See 

diagram 2.

11) Disconnect Piezo wire.

12) Remove two (2) thermopile wires.

13)  Remove thermocouple with a 9 mm (metric) 

wrench.

14) Remove pilot nut with an 11 mm wrench.

15) Remove valve to orifi ce nut with a 13/16" 

wrench.

16) Remove inlet pipe with pipe wrench. Note 

orientation of 90

o

 elbow.

17) Remove two (2) phillips head M5 screws 

on each side of the valve.

18)  Remove valve and remove gas out 90

o

 brass 

fi tting. Note orientation of fi tting.

1)  To install a new valve assembly, reverse 

instructions for removing valve.  See  as-
sembly steps 1-11.

2)  Check for leaks and manifold pressure. See 

Gas Pressure Test  instructions.

3)  To reinstall valve, reverse instructions for 

removing valve assembly, steps 12-18.