Regency F39-NG Manuel D’Utilisation

Regency

®

 F39 Room Sealed Freestanding Gas Stove

1)  Remove the door from the unit and place 

on a soft surface to prevent scratching.

2)  Pull out the door gasket.

3)  Remove the 24 nuts holding the glass 

retainers in place. Do not remove the nuts 
underneath the retainers.

4)  Remove the door catch plate.

5)  Remove glass retainers on sides fi rst (3 each 

side) then remove two center retainers.

6)  Remove glass from extrusions. When re-

moving center glass, leave white insulation 
in place.

2)  Place glass assembly into door frame.

3)  Install retainers by placing 1 drop of glue 

where previously glued and put in place.

4)  Install side retainers.

5)  Install door catch plate.

6)  Install the 24 nuts loosely, do not tighten 

yet.

1)  Install both center 

and side glass 
onto extrusions 
as per diagram.

Note:  Wearing gloves will protect your hands 

while handling glass.

1)  Remove the door from the unit and place on 

a soft surface to prevent scratching.

2)  Pull out the door gasket.

3)  Remove the nuts holding the glass retainers 

in place.

4)  Remove the glass retainers (sides, top and 

bottom) and the door catch plate.

5)  Replace the glass. The glass must have 

6)  Reverse the previous steps, replace the 

retainers and fasten with the nuts but do 
not overtighten, as this can break the glass. 
Note: the  door catch plate fi ts on top of the 
left side retainer.

7)  Put gasket glue on the retainers, but do not 

put glue on the screws. Replace the door 
gasket, the two ends butt tight together on 
the bottom edge of the door.

8)  Replace door on the stove and check the 

seal.

The unit should never be used with broken logs. 
Turn off the gas valve and allow the unit to cool 
before opening door to carefully remove the 
logs. The pilot light generates enough heat to 
burn someone. If for any reason a log should 
need replacement, you must use the proper 
replacement log. The position of these logs 
must be as shown in the diagram under Log 
Installation.  

 
If the door gasket requires replacement use 7/8" 
diameter oval door gasket (Part # 650-920). 

The door latch may require adjustment as the 
door gasket material compresses after a few fi res 
and after glass replacement. Turn the adjustable 
catch to tighten or loosen the latch.

Your Regency

®

 stove is supplied with high tem-

perature, 5 mm Neoceram ceramic glass that 
will withstand the highest heat that your unit will 
produce.  In the efl ue that you break your glass 
by impact, purchase your replacement door from 
an authorized Regency

®

 dealer only, and follow 

our step-by-step instructions for replacement. 
The glass is not sold separately, as it must be 
properly sealed in the door frame.

 

940-325/P F39 

Wraparound 

Glass

940-322/P 

F39 Panel Center Glass

940-323/P 

F39 Panel Side Glass