Quadra-Fire CB1200-B Manuel D’Utilisation

Page  20

7014-082D

September 1, 2008

R 

R 

R 

1.  Place the front log in first as shown in 

Figure 20.1.  Place 

log between firepot and face of appliance with charred 

area surrounding firepot.

2.  Set the left and right logs onto the front log, placing  

the holes in the base of the left and right logs over the 

locating pins in front log.  See 

Figure 20.2.  Ensure that 

the charred ends are facing the firepot.  

Logs are FRAGILE.  Use extreme care when handling or 

cleaning logs.

NOTE:  

Due  to  the  abrasive  nature  of  a  pellet  appliance  fire,  the 

logs are not covered under warranty.  Any placement varia-

tion other than shown here can cause excessive heat and 

shall void the appliance warranty.

supported by the hinges. It will damage the hinges.  Prop the

1.  Remove grille from packaging.
2.  Lift top up and place shipping box in vertically.
.  Place 1 flap of the box lid into opening for stability.
4.  Align the  holes in the stove with the holes in the grille.
5.  Use a Phillips screwdriver to secure in place.
6.  Remove shipping box and lower top.

Install Logo

1.  Remove logo from packaging.
2.  The logo has 2 studs on the back.
.   Install the logo on the lower left side of the center 

panel by pressing the 2 studs into the pre-drilled 

holes.  

Do not open top all the way back so the weight of the 

top is supported by the hinges.

hinges.  It will be necessary to prop the top up with 

a supporting brace.  You can use the shipping box as 

shown in Figure 1.