Fusion INTELPage IP 5 Manuel D’Utilisation

Manual 

 

Fusion Intelpage IP 

© 

Wireless 

 Page 

11

 

Before mounting the enclosure, you will need to decide where to place the unit. The 
Intelpage IP comes default with rubber feet installed, allowing it to sit on a desk or table, 
or be stacked upon other plastic Fusion Series modules. 

The kit also includes a wall mounting bracket. To install this bracket: 

1.  Use a philips screwdriver to remove the four screws holding the rubber feet 

2.  Seat the bracket on the base of the unit. It will only fit one way around. 

3.  Use the screws that used to hold the rubber feet in position, to hold the wall 

mount bracket in position. 

 

 

A suitable antenna capable of handling 5 watts must be connected to the BNC connector 
on the rear panel. The antenna for the unit must not be mounted within 5 metres of any 
other sensitive electronic equipment including other Fusion series products, routers, 
computers or phone systems. See the technical information section below for further 
infomation. 

▲