England's Stove Works 60-SHBVNG Manuel D’Utilisation
LIGHTING INSTRUCTIONS
1. STOP! Read “For Your Safety” above.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with a manual
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with a manual
piezoelectric ignition device. Do not attempt
to light the pilot by hand.
to light the pilot by hand.
5. Turn gas valve control knob fully clockwise
→
to “OFF.”
6. Wait five (5) minutes to clear out any gas. If
you then smell gas, STOP! Follow the
“For Your Safety Read Before Lighting”
information earlier. If you do not smell gas,
go to the next step.
“For Your Safety Read Before Lighting”
information earlier. If you do not smell gas,
go to the next step.
7. Be sure the thermostat is set at the lowest
setting.
8. Turn the gas valve control knob
counterclockwise
←
to “PILOT.”
9. Push in the gas valve control knob and hold
it in while pushing the button of the
piezoignitor. Push the piezoignitor button
several times while holding the gas valve
control knob in.
piezoignitor. Push the piezoignitor button
several times while holding the gas valve
control knob in.
10. After the pilot has ignited, you may cease
pushing the piezoignitor button. Continue to
hold the gas valve control knob for
approximately 30-60 seconds. Release the
gas valve control knob and it will “pop” out.
hold the gas valve control knob for
approximately 30-60 seconds. Release the
gas valve control knob and it will “pop” out.
If the knob does not pop up when
released, stop and immediately call your
service technician or gas supplier.
service technician or gas supplier.
The pilot is now lit.
11. For the very first lighting, it may take several
attempts to purge air from the gas line. If
pilot ignition does not occur or the pilot goes
out, repeat steps 9 and 10.
pilot ignition does not occur or the pilot goes
out, repeat steps 9 and 10.
12. Turn the gas valve control knob fully
counterclockwise
← to “ON.”
13. Turn on all power to appliance.
14. Set thermostat to desired setting.
15. If the appliance will not operate, follow the
instructions “TO TURN OFF GAS TO
APPLIANCE” and call your service
technician or gas supplier.
APPLIANCE” and call your service
technician or gas supplier.
16. Shut the gas valve access door.
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if
2. Turn off all electric power to the appliance if
service is to be performed.
3. Turn gas valve control knob fully clockwise
→ to “OFF.” Do not force.
4. Shut gas valve access door.
1. White Rogers Pilot Light Assembly
(located in the firebox)
2. Spill Switch (located in the draft hood
beneath the flue collar)
3. Wall
Thermostat
4. Piezoelectric
Spark
Ignitor (located near
the gas control valve)