Jasco ZWAVEKIT Manuel D’Utilisation
The auxiliary switch is not Z-Wave enabled and does not
directly control electrical loads. It must be used with a
compatible Z-Wave enabled, 3-wire switch in three-way
installations where a light is controlled from 2 locations
such as the top and bottom of a staircase. This switch
communicates with the Z-Wave enabled switch, providing
manual On/Off/Dim control of the connected lighting (through
the Z-Wave enabled switch) and synchronization of the
lighting status (On/Off/Dim level) between the two switches.
This dimmer is designed for use only with permanently
installed incandescent lighting fixtures. Do not use it to
control fluorescent lighting, transformer supplied lighting/
appliances, motorized appliances or receptacles. The
incandescent lighting controlled by this dimmer must not
exceed a total of 500 watts.
There are no user serviceable
parts in this unit.
Dimmer switch
This device is intended for installation in accordance
with the National Electric Code and local regulations
in the United States, or the Canadian Electrical Code
and local regulations in Canada. If you are unsure or
uncomfortable about performing this installation
consult a qualified electrician.
with the National Electric Code and local regulations
in the United States, or the Canadian Electrical Code
and local regulations in Canada. If you are unsure or
uncomfortable about performing this installation
consult a qualified electrician.
CAUTION
LED light
Air gap switch