Sunrise Medical 900-1086 Manuel D’Utilisation
ASSEMBLY INSTRUCTIONS
REQUIREMENTS
Failure to meet requirements listed below could result in serious bodily harm.
•
Wall mount should be installed by a skilled tradesperson. Installation of the wall
mount by someone unskilled will void Sunrise warranty and may cause serious injury
or damage.
mount by someone unskilled will void Sunrise warranty and may cause serious injury
or damage.
•
Every month a maintenance check should be done to ensure the rail is level (see
“Maintenance” in this manual).
“Maintenance” in this manual).
•
Protect the Easytrack System and its accessories during transport.
•
Wall Requirements:
WOOD STRUCTURE – minimum 2” X 3” Studs
CONCRETE STRUCTURE
WOOD STRUCTURE – minimum 2” X 3” Studs
CONCRETE STRUCTURE
•
Do no install if wall does not meet requirements.
•
Do not install on a wall with a steel structure.
BEFORE YOU BEGIN
Read “Requirements” and “Important Safeguards” before attempting to assemble
the Easytrack System.
the Easytrack System.
1. Survey the room where you plan to install the Easytrack Wall Mount. Make sure the
room meets all the specifications outlined in “Requirements”.
2. Use the measurements below to determine the best place to put the Easytrack System:
a. Over a bed – approx. 36-40” (915-1020 mm) from the head of the bed (Figure 1).
b. Over a tub – approx. 16-18” (400-460 mm) from the end of the tub (Figure 1).
c. Allow 36” (915 mm) of open area for transfer working space (Figure 2).
d. Allow a minimum of 53” (1340 mm) from the bottom of the rail to the top of any
b. Over a tub – approx. 16-18” (400-460 mm) from the end of the tub (Figure 1).
c. Allow 36” (915 mm) of open area for transfer working space (Figure 2).
d. Allow a minimum of 53” (1340 mm) from the bottom of the rail to the top of any
object to be transferred over (Figure 3).
3. Transfers should only take place under the Easytrack rail (Figures 4 & 5).
4. The Wall Mount may be installed on either a concrete wall or wood-framed wall. For
4. The Wall Mount may be installed on either a concrete wall or wood-framed wall. For
wood, the wall mount must be attached to a minimum of three (3) 2" X 3" studs. DO
NOT attempt to install the wall mount on less than 3 studs (Figure 6).
NOT attempt to install the wall mount on less than 3 studs (Figure 6).
5. Wall Mount must be positioned on the wall to ensure the angle between the wall and
the rail will be more than 30° (Figure 7).
Wall Mount Assembly
4
A s s e m b l y I n s t r u c t i o n s
1
2
3
4
5
6
studs
wall mount plate
7
30°
30°
Maximum angle
36-40"
(915-1020mm)
53"
(1340mm)
80.2-130"
(2040-3300mm)
84.8-134.5"
(2155-3415mm)
20"
(510mm)
84-108"
(2130-2745mm)
16-18"
(400-460mm)