Lightolier 302MRIC7X Fascicule

Rev: 02

 

3 3/4" (95mm)

Accepts few 3 3/4" (95mm) 300 serie trims ; see Reflector
Trim specification sheets.

Mounting Frame: 20ga. galvanized steel. Four slots are positioned  90º

apart to simplify alignment.

20" (508mm) long. Set of 2

Insulated ceiling Housing: .018" galvanized steel. CSA certified
for direct contact with thermal insulation. Internal thermal cut-out insures against

overheating due to incorrect lamping.  

To lock mounting bars in place after installation. Set of 12.

Mounting Bars: (4) 18 ga. galvanized steel. 13" (330mm) long bars extend to
27" (686mm), rotatable and lockable, integral T-bar tabs. Spike detail

eliminates the need of additional nailing. 

Polyvinyl Air Vapour Barrier ; to comply with provincial legislation. For all

Mounting Bars Locking Clip: (1) locks mounting bars in place. Additional

non Air-Seal frame-In-Kits.

clips are sold separately (0098 set of 12)
Socket :  Porcelain body ; Two-pin (GX5.3 base) Pre-wired with 18 ga. Teflon
250º leads to junction box. 

Transformer: Magnetic 50VA, 120 volts primary, nominal 12 volts secondary, 
class "H".  (integral thermal protector)

Dimming controls: use only dimmers specifically designed for use with

Junction Box: 4"(102mm) x 3"(76mm) x 2"(51mm) 18 ga. galvanized steel .

transformers, like Lightolier Onset, Sunrise series LV or VA dimmers, or any

CSA/UL certified for maximum of  4 No. 12 ga. 90º C through branch circuit

Lightolier Controls dimming system. Low voltage fixtures may produce audible

conductors. Integral cable clamp permit attachment of  non metallic Loomex

noise. Attention should be given for noise sensitive applications.

without need of additional connectors. Pry-out knock-outs accept BX cable.
Easy access from both sides with snap-on covers.
Lamp cover: Aluminum heat deflector for 50W MR16 / 37W MR16 IR or
ES/ESD16 dichroic lamps.

Damp or Wet location rated depending on trim used.

WE RESERVE THE RIGHT TO CHANGE DETAILS OF DESIGN,  MATERIALS AND FINISH, IN ANY WAY

THAT WILL NOT ALTER INSTALLED APPEARANCE OR REDUCE FUNCTION AND PERFORMANCE.