Lightolier 26046 Fascicule

FALL RIVER, MASSACHUSETTS 02720
MONTREAL, QUEBEC, CANADA

 © 1997

™

The Power Extension Connector allows power to be jumped from one
track, around or through structural obstacles, to another track unit. It
replaces the Dead End Cover at the end of a Feed Track unit or a run
of track units. Power can be fed into or removed from the Power
Extension Connector by using any of the power feed-in kits available
for ProSpec Track. A few examples are shown on the reverse side.

Caution:
• Turn off power at fuse box before installing the Power

• Instructions for grounding must be followed. Failure to do

• Use only #12 ga. solid copper wire in connectors to

• Observe polarity, white (neutral) wire must be connected

• Do not use Track as a conduit support. Independent conduit

INSTALLING CONNECTOR INTO TRACK SECTION--Fig.1 & Fig. 2

1. Remove Dead End Cover if necessary by pulling it out of the track

(save Dead End cover).

2. Push connector into the track until there is no gap between the

track unit and connector. Ensure that the contact blades are
aligning with the copper wirers in the track during assembly.

3. Tighten the locking screw.

DIRECT FEED FROM ABOVE CEILING--Fig.3
1. Remove the bottom cover (if required) by snapping it out of the

connector. Save cover.

2. Remove K.O. plate from the connector.
3. Remove the K.O..
4. Attach the electrical connector onto the K.O. plate using the nut

provided. Align the electrical connector such that the connector is
hidden by the track width.

5. Attach the K.O. plate onto the connector using the screw that was

previously removed.

6. Pass cable or conduit through electrical connector and clamp cable

or conduit to electrical connector.

7. Form the wires to the appropriate screw terminals. Cut and strip

wires and attach to the screw terminals. (See wiring section of
instruction sheet).

8. Snap the bottom cover onto the connector.

Connector

Track Unit

Connector

Track Unit

Locking Screw

Fig. 2

Dead End

Track Unit

Bottom Cover

Electrical

Connector

(by Others)

Knock Out

Nut

Conduit or Cable
(by Others)

K.O. Plate

Fig. 3

Bottom Cover

Fig. 1

Track Unit

Dead End

READ AND UNDERSTAND ALL TRACK, CONNECTOR, FEED-IN-KITS, AND ACCESSORY

INSTRUCTION SHEETS BEFORE INSTALLING ANY PROSPEC™ TRACK ITEM.

This fixture is intended for installation in accordance with the National Electrical Code and local or Federal
code specifications. To assure full compliance with codes and regulations, check with your local electrical
inspector before installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.