Lightolier IS:1104ICN Fascicule

INSTRUCTION SHEET NO.

IS:1104ICN

C1204

Page 1 of 2

INSTALLATION PROCEDURE FOR CONVERTIBLE IC/NON IC

FRAME-IN-KITS 1004ICN, 1004SICN, 1104ICN, 1104SICN

1. FRAME-IN (Fig. A)

Locate fixture along joist and line up bottom edge of HINGED
MOUNTING BAR with the bottom of joist and fasten in place.

NEW CONSTRUCTION

Remove the peel off label on the
outside of the housing section.

For IC Installations:

Remove the lower portion of
the ROUGH-IN LABEL as shown.
Non-IC rough-in sections are
listed for higher wattage lamps.

For Non-IC Installations:

Fig. A
Frame-In

Fig. B
Wire-In

Fig. C
Swing-Up

Fig. D
Close-In

Fig. E
Snap-On

Fig. F
Push-Up

ROUGH-IN LABEL

SOCKET CUP

For suspended ceilings:

• Rotate HINGED BAR ENDS to position shown and

fully extend bars.

• Crimp bottom of edge of CHANNEL to prevent

rotation of HINGED BAR ENDS.

• Bend NON-HINGED end of mounting bar at featured

hole location and extend out.

• Position notched area of MOUNTING BARS onto

T-BAR and lock by bending TAB underneath T-BAR
BEAD as shown.

HINGED MOUNTING BAR

T-BAR

TAB

3”

1004IC

” 1104IC

” 1004IC

” 1104IC

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

CONVERTIBLE IC/NON-IC HOUSING

IC APPLICATIONS:

REMOVE THIS

WARNING LABEL. SEE INSTRUCTION SHEET.

NON-IC APPLICATIONS:
WARNING - RISK OF FIRE

DO NOT INSTALL INSULATION WITHIN 3
INCHES OF FIXTURE SIDE OR WIRING
COMPARTMENT NOR ABOVE FIXTURE IN
SUCH A MANNER TO ENTRAP HEAT.

LIGHTOLIER a GENLYTE company.
631 Airport Road, Fall River, MA 02720

BEND TAB

TO LOCK

TAB

HINGED BAR ENDS

CHANNEL

BEND AT HOLE