Lightolier 4X9EM Manuel D’Utilisation
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTALLATION PROCEDURE FOR: 4X9 AND 9X9 MATRIX SERIES RECESSED
COMPACT FLUORESCENT EMERGENCY LIGHTING FRAME-IN KITS
INSTRUCTION SHEET NO.
IS:4X9EM
A0502
Page 1 of 4
A
COMPANY
631 Airport Road, Fall River, MA 02720
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED INCLUDING:
1. Turn off AC power before proceeding.
2. Do not use outdoors.
3. Do not mount near gas or electrical heaters.
4. Do not attempt to service the battery. A sealed, rechargeable, no maintenance battery is used. Do not incinerate
2. Do not use outdoors.
3. Do not mount near gas or electrical heaters.
4. Do not attempt to service the battery. A sealed, rechargeable, no maintenance battery is used. Do not incinerate
or mutilate; may burst or release toxic materials. Do not short circuit; may cause burns. Battery acid can cause
burns to skin and eyes. If acid is spilled on skin or eyes, flush with fresh water and contact a physician
immediately.
burns to skin and eyes. If acid is spilled on skin or eyes, flush with fresh water and contact a physician
immediately.
5. Equipment should be mounted in locations and at a height where it will not be readily subject to tampering by
unauthorized personnel.
6. The use of accessory equipment is not recommended by the manufacturer and may cause an unsafe condition.
7. Do not use the equipment for other than intended use.
8. This unit has more than one power supply connection point. To reduce the risk of electrical shock, disconnect both
7. Do not use the equipment for other than intended use.
8. This unit has more than one power supply connection point. To reduce the risk of electrical shock, disconnect both
the normal and the emergency power supplies before servicing.
9. Before servicing to prevent electrical shock, disconnect the battery connectors on the emergency pack (location
on the end of the emergency pack). Make certain that the switch (if the fixture is switched) and the unswitched
lines to the emergency pack are turned off at the fuse box. Servicing should be performed by qualified personnel
only.
lines to the emergency pack are turned off at the fuse box. Servicing should be performed by qualified personnel
only.
10. Be sure all electrical connections are complete before battery (inverter) connectors on emergency Pack are
connected.
11. The emergency battery pack must be fed from the same branch circuit as the AC ballast(s).
12. In switched fixtures, emergency pack must be connected ahead of any local switching.
13. Select the appropriate wiring diagrams to connect the emergency pack and the AC ballasts (see page 4).
12. In switched fixtures, emergency pack must be connected ahead of any local switching.
13. Select the appropriate wiring diagrams to connect the emergency pack and the AC ballasts (see page 4).
SAVE THESE INSTRUCTIONS
4X9142HUEM Shown.