Lightolier 6422MC Fascicule

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTRUCTION SHEET NO.

I S : 6 4 2 2 M C

0498

Page 1 of 2

INSTRUCTIONS FOR ATTACHING LYTESPOT

TO LYTESPAN

TRACK

For use with Lytespan

Track Systems Only

LIGHTOLIER a GENLYTE company.
631 Airport Road, Fall River, MA 02720

1. Insert into LYTESPAN TRACK. (Fig. 1) LOCKING LEVER

must be on the same side of track as BEAD.

2. Rotate FITTING clockwise until LOCKING LEVER snaps

and locks in place. (Fig. 2 & 3)

3. To remove: depress LOCKING LEVER, then rotate FITTING

90° counterclockwise.

INSTRUCTIONS FOR ATTACHING LYTESPOT

SINGLE CIRCUIT TRACK SYSTEMS

Fig. 1

BEAD

See Fig. 4. BRASS CONTACT can be raised or lowered.
Broken line indicates position for 1 circuit or lower circuit
of 2 circuit track system.

To convert attachment FITTING for upper circuit of 2 circuit
track, raise BRASS CONTACT to high position by lifting
CONTACT as high as stop permits and CONTACT clicks
into place.

INSTRUCTIONS FOR CONVERTING LYTESPOT

ATTACHMENT FITTINGS TO OPERATE ON 2
CIRCUIT TRACK

Fig. 2

Fig. 3

Fig. 4

LOCKING

LEVER

LYTESPAN TRACK

FITTING

LOCKING
LEVER

BRASS CONTACT