Cooper Lighting ADY071473 Manuel D’Utilisation

Vault

Sheet 1 of 3

C-Scroll

Roundel

These installation instructions are valid with the above Ametrix styles.

Visor and Non-Visor

Warning

that all sources of power are turned off. All

performed by a certified electrician.

: Before starting any work ensure

work must meet local/national codes and be

Do not

mount fixtures vertically.

Installation Instructions

Large, OUTDOOR

P1R

(Pendant, 1-way, Remote ballast)

ADY071473 REV A(ECN070347)

(2x)

Mounting and wiring fixture

Mounting plate

#10-32 x 3/8"

Canopy

Hex cap screw

(2x)

1/4-20x 3/4"

(2x)

End screw

Exploded view and part call-out

Pan head screw

#10-32

Appropriate fasteners

(by others)

(2x)

Sealing the fixture

Securing fixture to pendant

(2x)

Socket cap screw

#6-32 x 5/8"

#6-32 x 1/2"

Wire seal

Socket cap screw

1. To seal fixture, secure all socket cap screws according to

sequence and torque specifications on supplementry sheet.

2. Ensure a smooth and sealed connection at wire seal.

3. For aiming instructions refer to aiming supplementry sheet

Mount yoke to pendant with both 1/4-20 Hex cap screws.

Hex cap screw

Wire connector

End screw

Flat head screw

End cap

Yoke

1/4-20 x 3/4"

Mounting plate

#6-32 x 1/4"

(2x)

mounting plate and reattach fixture head to yoke.

Feed fixture wire through connector in pendant up through

(2x)

1. Begin by removing end screw, #6-32 x 1/4" Flat head screw

and end cap from one side of Yoke and remove fixture head.

Fixture wire

#6-32 x 3/8"

(2x)

Replace canopy and secure with both #6-32 x3/8" Pan head

screws.

Attach appropriate wires and ensure all connections are

Attention:

Large fixtures require additional bracing/structure

around J-box to support fixture.

J-box

(by others)

Canopy

properly matched.

Pan head screws

1. Loosen #6-32x 3/8" Pan head screws and allow canopy to slide

down pendant.

2. Feed wires from J-box through wire ways in mounting plate

and secure fixture to bracing around J-box.

Use additional bracing

around J-box to support

fixture.

Appropriate

fasteners

(by others)

(4x)